Hdmi 1 Audio; Hdmi Settings; Digital Audio Output - Toshiba 32AV623D Owner's Manual

CONTROLS AND FEATURES

HDMI 1 Audio

If the connected HDMI source does not support digital audio,
plug the audio cable into PC/HDMI 1 (AUDIO) on the back of
the television (as shown in the 'Connecting an HDMI™ or DVI
device to the HDMI input' section), then use the HDMI 1 Audio
setting.
a
In the AV Connection menu press
HDMI 1 Audio and using
b
Then highlight HDMI 1 Audio and using
Auto or Analogue.
AV Connection
PC/HDMI 1 Audio
HDMI 1 Audio

HDMI Settings

EXT 2 Input

Digital Audio Output

If the sound is missing select an alternative setting.
NOTE: HDMI 1 supports digital and analogue sound,
HDMI 2, HDMI 3 and HDMI 4 are digital sound only.
Certain DVD disk formats may not output from this TV
(32/44.1/48kHz and 16/20/24 bits are acceptable).
HDMI Settings
Some early HDMI equipment may not work properly with your
HDMI TV, please unplug your HDMI cable first and then try
setting the Lip Sync and INSTAPORT™ options to Off.
Adjusting these settings should allow your early HDMI source to
operate properly with your television.
a
In the SETUP menu press
highlighted, then press
b
b
Press to highlight HDMI Settings and press
NOTE: HDMI Settings is grayed out on non-HDMI
inputs.
HDMI, the HDMI logo, and High-Definition Multimedia Interface
are trademarks or registered trademarks of HDMI Licensing,
LLC.
INSTAPORT™ and INSTAPORT logo are trademarks of Silicon
Image, Inc. in the United States and other countries.
b
to highlight PC/
c
select HDMI 1.
C c
or select
HDMI 1
Auto
AV
Auto
b
until AV Connection is
Q
.
Q
.
c
B b
Press or
select the settings.
HDMI Settings
Lip Sync
INSTAPORT TM
RGB Range
• Lip Sync: On
This option activates an auto audio/video display timing
adjustment function that allows HDMI source devices to
accurately perform synchronization automatically.
All above HDMI settings need proper HDMI source device.
If HDMI source products does not support these features, the
television may not work properly by activating these
features.
• INSTAPORT™: On
This feature reduces the lag of switching time when
switching HDMI sources.
• RGB Range: Auto
This feature adjusts RGB full range signal automatically.
When Limited is selected, RGB output signal is output in the
range from 16 to 235. When Full is selected, RGB output
signal is output in the range from 0 to 255.
NOTE: If your HDMI connection is capable of 1080p and/or
your television is capable of refresh rates greater than 50Hz or
supports Deep Colour, you will need a Category 2 cable.
Conventional HDMI/DVI cables may not work properly with
this mode.
Digital Audio Output
When connecting a surround sound amplifier to the digital
audio output (Sony/Philips Digital Interface Format
[S/PDIF]), the following options can be selected.
PCM: this mode outputs PCM format to the digital audio output
Auto: this mode outputs Dolby Digital or PCM to the digital
audio output socket providing it is being broadcast.
S
Dolby Digital
Dolby Digital Plus
S
MPEG PCM
a
In the AV Connection menu press
Audio Output.
b
C c
Use or to select PCM or Auto.
40
C
to select option, then press
On
On
Auto
socket.
Dolby Digital
S
Dolby Digital
b
to select Digital
c
or to