Remote Control - Mitsubishi Electric DLP XD700U User Manual

Remote control

Battery installation
Use two (AA, R6) size batteries.
Inserting the batteries into the remote control
1. Remove the back cover of the remote control by pushing the battery compartment door in the direction of the arrow.
3. Replace the back cover.
Removing the batteries from the remote control
Remove the back cover of the remote control and take out the batteries.
Caution:
terminals. If you dispose of the batteries together with other conductive objects such as a metal piece, they may short
out, resulting in fire or explosion.
Batteries may explode if misused. Do not recharge, disassemble, or heat the batteries, or put them into fire or water.
with your eyes, rinse them with water and then consult your doctor.
may short out, causing explosion or liquid leakage and resulting in fire or injury.
High temperature and high humidity may cause corrosion or liquid leakage.
Operation range (of the remote control)
pointed at the remote control sensor of the projector. When the remote control is pointed to the screen, the distance
from the remote control to the projector via the screen should be 5 m or less. However, the operation distance varies
depending on the type of the screen used.
Reception angle (horizontal)
Important:
between the remote control sensor and the fluorescent light to ensure correct operation of the remote control.
Inverted fluorescent light, if located near the projector, may interfere the remote control.
When you use the remote control too close to the remote control sensor, the remote control may not work correctly.
Reception angle (vertical)
Reception angle (vertical), ceiling mount
EN-8