Low Flame Adjustment - Maytag KGSC100S Installation Instructions Manual

After each burner has been checked, close cooktop and place drip bowls in burner openings. Ignite each burner
separately and examine soft blue inner core of flame. Burner flame adjustments were done in the factory and
inner cores should be approximately r/z inch. If adjustment is needed raise cooktop and engage suppport rod,
ignite burner, set at hi, if the flames lift from the burner reduce the air shutter opening. See Figure 6. If flames
are yellow open air shutter until you achieve a l/z inch soft blue inner core.
LOW FLAME ADJUSTMENT
The low flame setting is factory preset
and burner flames should be approximately l/e inch long. If adjustment
is required raise the cooktop and hold in place with the support rod. Place knob on valve stem, ignite and turn
burner to "lo" setting. Remove knob. Using pliers to hold the valve stem at its base, insert a 3/16" narrow standard
blade screwdriver in adjustment slot. See Figure 6. Turn screw until flame is lh inch long. Close cooktop.
INSTALL GRATES
Rotate drip rings so that hole in cooktop is exposed by the notch in the ring. Place pin on bottom of gr+elin slot.
Grate should sit level on drip bowl.
Refer to Installation Checklist on front cover of this booklet.