Error Indicators And Warnings; Maintenance; Specifications - Sharp QT-V5E Operation Manual

Error indicators and warnings

When you load an unplayable disc or fail to perform operations properly, the following
messages are displayed on the TV screen.
TV screen
The region number of the DVD is not 2 or ALL.
WRONG REGION

Maintenance

! Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then with a
dry cloth.
" Do not use chemicals for cleaning (petrol, paint thinner, etc.). It may damage the
cabinet finish.
" Do not apply oil to the inside of the equipment as this may cause malfunctions.
! Cleaning the laser pickup lens
Poor performance during DVD/CD playback (skipping or jumping) can be caused by a
dirty or contaminated laser pick up lens. If this happens then the use of a commer-
cially available lens cleaning discs may restore normal operation. Contact your sup-
plier or local DVD software dealer to obtain lens cleaning discs. Ensure all included
instructions/documentation are carefully followed.
! Care of discs
Discs are fairly resistant to damage, however mistracking can occur due to an accu-
mulation of dirt on the disc surface. Follow the guidelines below for maximum enjoy-
ment from your disc collection and player.
" Do not write on either side of the disc, particularly the non-label side from which
signals are read. Do not mark this surface.
" Keep your discs away from direct sunlight, heat, and excessive moisture.
" Always hold the discs by the edges. Fingerprints, dirt, or water on the discs can
cause noise or mistracking. If a disc is dirty or does not play properly, clean it with
a soft, dry cloth, wiping straight out from the centre, along the radius.
NO

Specifications

As part of our policy of continuous improvement, SHARP reserves the right to make
design and specification changes for product improvement without prior notice. The
performance specification figures indicated are nominal values of production units.
Meaning
There may be some deviations from these values in individual units.
Power source
Power consumption
Output power
Speakers
Dimensions
Weight
Signal system
Supported disc types
Video signal
Audio signal
Audio output termi-
nals
YES
Video output termi-
Correct
nals
Frequency range
04/6/15
AC 230 - 240 V, 50 Hz
DC 12 V ["D" size (UM/SUM-1, R20 or HP-2) battery 8]
DC 3 V ["AA" size (UM/SUM-3, R6 or HP-7) battery 2 for
memory]
23 W
RMS: 10 W (5 W + 5 W) (10 % T.H.D., 1 kHz)
8 cm full-range speaker 2
Width: 420 mm
Height: 150 mm
Depth: 260 mm
5.2 kg
PAL/NTSC colour
DVD (region number 2 or ALL), SVCD, VCD, audio CD,
CD-R, CD-RW, MP3
Horizontal resolution: 500 lines
S/N ratio: 50 dB
Frequency character- Linear PCM DVD:
istics
20 Hz to 20 kHz (sampling rate:
48 kHz)
20 Hz to 20 kHz (sampling rate:
96 kHz)
CD: 20 Hz to 20 kHz
S/N ratio CD: 80 dB (1 kHz)
Dynamic range Linear PCM DVD: 70 dB
CD: 70 dB
Total harmonic distor- 0.01 % maximum
tion ratio
Headphones: 16 - 50 ohms (recommended: 32 ohms)
Optical digital output: Square type 1
Analogue output: RCA type 1 pair (L/R)
SCART output: SCART terminal 1
Video output: RCA type 1
S-video output: S-terminal 1
FM: 87.5 - 108 MHz
AM: 522 - 1,620 kHz
QT-V5E_UK_4.fm
QT-V5E
1
2
3
4
5
6
7
8
39
9HX80432100003