Advertisement
The thermo-hygro sensor measures outdoor temperature & humidity and collects the data from the wind and the rain sensors
and sends all outdoor weather data to the wireless display, so the thermo-hygro sensor must be within the 200 foot wireless
range of the wireless display. This allows the wind and rain sensors to be placed relative to the thermo-hygro sensor rather
than the wireless display. See Wireless Data Diagram above.
The wind and rain sensors must be mounted within the 200 foot wireless range of the thermo-hygro sensor and on the
same side of the house.
The wireless display must be within the 80 foot wireless range of the USB transceiver to send weather data to the PC.
If the sensor wireless icons
far from the wireless display. Try moving the wireless display or the sensors closer and wait a few minutes to see if the
wireless icons
display again. If the wireless icons
display, press and hold the UP ARROW (▲) key for 2 seconds to re-synchronize the wireless display with the sensors.
Wind sensor
The wind sensor must be installed with the front of the sensor (the solar panel) facing true South, or the reported wind
direction will not be accurate. Mount within the 200 foot wireless range of the thermo-hygro sensor and on the same side of
the house. The roof may or may not be an ideal mounting location. Secure the main unit to the shaft of the mast holder. Use
the right-angle adaptor if the wind sensor will be mounted on a horizontal mast or surface.
Fasten the wind sensor to a suitable mast using the two U-bolts, washers and nuts included. Note: Mount the wind sensor
onto a mast so the wind can reach the sensor unobstructed from all directions for an accurate reading. The ideal mast is
between 0.62" and 1.3" in diameter. The wind sensor DOES NOT have replaceable batteries, it consumes solar power and
charges the internal battery pack automatically.
Rain sensor
The rain sensor should be mounted on a level surface in an open area within the 200 foot wireless range of the thermo-hygro
sensor and on the same side of the house. Mount the rain sensor at least 1 foot off the ground level for optimum wireless
transmission. The rain sensor should be accessible to allow for period cleaning of debris or insects.
Thermo-Hygro Sensor
The thermo-hygro sensor is "weather resistant", but not "water proof". To ensure an extended life of your sensor, mount it in a
semi-covered place out of the elements. An ideal location for the thermo-hygro sensor is under the eaves on the North side of
the house to avoid the effects of sunlight. Mount the sensor 18" down from the eaves to ensure optimum performance. This
way the weather data collected by the sensor will not be affected by the temperature of the air coming out of the attic.
To wall mount the thermo-hygro sensor, fix the wall holder onto the desired wall using the included screws, plug the sensor
firmly into the wall holder and replace the rain cover if it is not already in place. Note: After mounting the units, if the weather
data is not received, press and hold the UP ARROW (▲) key for 2 seconds to synchronize the wireless display to the sensors.
Use your PC to store and graph the latest weather data collected by the weather station. Download the Heavy Weather PC
software from www.lacrossetechnology.com/2810. See the download page for installation instructions and computer
requirements.
FCC DISCLAIMER
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1)
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
(2)
drop from the display as you move them into their intended locations, the sensors may be too
are still not displayed after re-positioning the sensors or the wireless
Heavy Weather PC Software
EJMA2810L211
Printed in China
Advertisement
