Diagnostic Start - Cisco Catalyst 3120 Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

diagnostic start

Use the diagnostic start privileged EXEC command to run an online diagnostic test.
Syntax Description
switch number
test
name
test-id
test-id-range
all
basic
non-disruptive
Defaults
This command has no default setting.
Command Modes Privileged EXEC
Command History Release
12.2(40)EX
Usage Guidelines The switch supports these tests:
ID
---
1
2
3
4
5
6
7
---
When specifying a test name, use the show diagnostic content privileged EXEC command to display
the test ID list. To specify test 3 by using the test name, enter the diagnostic start switch number test
TestPortAsicCam privileged EXEC command.
OL-12248-01
diagnostic start switch number test {name | test-id | test-id-range | all | basic | non-disruptive}
Specify the switch number, which is the stack member number. If the
switch is a standalone switch, the switch number is 1. If the switch is in a
stack, the range is 1 to 9, depending on the switch member numbers in the
stack.
Specify the tests to run.
Specify the name of a test. For more information, see the "Usage
Guidelines" section.
Specify the ID number of a test. The range is from 1 to 7. For more
information, see the "Usage Guidelines" section.
Specify more than one test with the range of test ID numbers. For more
information, see the "Usage Guidelines" section.
Specify all the diagnostic tests.
Specify the basic on-demand diagnostic tests.
Specify the nondisruptive health-monitoring tests.
Modification
This command was introduced.
Test Name [On-Demand Test Attributes]
-------------------------------------------
TestPortAsicStackPortLoopback
TestPortAsicLoopback
TestPortAsicCam
TestPortAsicRingLoopback
TestMicRingLoopback
TestPortAsicMem
TestInlinePwrCtlr
-------------------------------------------
[B*N****]
[B*D*R**]
[B*D*R**]
[B*D*R**]
[B*D*R**]
[B*D*R**]
[B*D*R**]
Cisco Catalyst Blade Switch 3120 for HP Command Reference
diagnostic start
2-87