Configuring Snmp Notifications - Cisco Catalyst 3120 Software Manual

Chapter 32 Configuring SNMP
Command
Step 4 snmp-server user username groupname
{remote host [udp-port port]} {v1 [access
access-list] | v2c [access access-list] | v3
[encrypted] [access access-list] [auth {md5 |
sha} auth-password]}
Step 5
end
Step 6 show running-config
Step 7
copy running-config startup-config

Configuring SNMP Notifications

A trap manager is a management station that receives and processes traps. Traps are system alerts that
the switch generates when certain events occur. By default, no trap manager is defined, and no traps are
sent. Switches running this Cisco IOS release can have an unlimited number of trap managers.
Note Many commands use the word traps in the command syntax. Unless there is an option in the command
to select either traps or informs, the keyword traps refers to either traps, informs, or both. Use the
snmp-server host global configuration command to specify whether to send SNMP notifications as
traps or informs.
Table 32-5
traps and configure a trap manager to receive them.
Table 32-5
Notification Type
Keyword
bgp
bridge
OL-12247-01
Purpose
Add a new user for an SNMP group.
•
•
•
•
•
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
describes the supported switch traps (notification types). You can enable any or all of these
Switch Notification Types
Description
Generates Border Gateway Protocol (BGP) state change traps. This option is
only available when the IP services feature set is enabled.
Generates STP bridge MIB traps.
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
The username is the name of the user on the host that connects
to the agent.
The groupname is the name of the group to which the user is
associated.
Enter remote to specify a remote SNMP entity to which the
user belongs and the hostname or IP address of that entity with
the optional UDP port number. The default is 162.
Enter the SNMP version number (v1, v2c, or v3). If you enter
v3, you have these additional options:
encrypted specifies that the password appears in
–
encrypted format. This keyword is available only when
the v3 keyword is specified.
auth is an authentication level setting session that can be
–
either the HMAC-MD5-96 (md5) or the HMAC-SHA-96
(sha) authentication level and requires a password string
(not to exceed 64 characters).
(Optional) Enter access access-list with a string (not to exceed
64 characters) that is the name of the access list.
Configuring SNMP
32-11