Pioneer DRM-7000 Operating Instructions Manual page 44

2. Connect the power cord from the Changer to the drive.
3. Connect the Changer Interface cable to the drive.
4. Allow the DRM-7000 to read the SCSI IDs on the drive(s).
If all drives have individual SCSI IDs, a buzzer sounds once. If there are duplicate IDs
assigned to separate drives then the buzzer sounds three times. Each device on a SCSI
bus requires a unique SCSI ID.
5. Connect the SCSI interface cable.
Any drives disconnected during an earlier step, should be reconnected at this time.
6. Enter the Config submode from the System Administrator mode.
Verify that the DRM-7000 recognizes all drives before proceeding. Check the wiring monitor
indicator on the back of each drive if necessary.
For example: the following messages appear when three DVD-ROM drives and a CD-ROM
drive are added to the rear bays beginning from bay #1.
B a y # 1 = D r i v e 1
DVDROM DVD-D7563
Press the Up arrow button
B a y # 2 = D r i v e 2
DVDROM DVD-D7563
Press the Up arrow button
- 40 -
DRM-7000
• Verify that the wiring monitor indicator on
the rear of the drive lights as
• Check that the termination indicator is
green if the Termination Switch is ON
• Confirm that the interface cable is
connected to the correct bay
Caution: Connecting the interface cable to an
incorrect bay port results in damage to the discs.
Operating Instructions
orange