Advertisement
Turn the locator to adjust the depth. Ini-
I
tially, adjust the locator so that the tip of
the locator is flush with the base of the
screw head. One full turn of the locator
equals 1.5 mm (1/16") change in depth.
After adjusting the locator, unlock the
locking sleeve.
Turn the locking sleeve slightly so that the
protrusions on the locking sleeve engage
in the notches in the locator. Drive a trial
screw into your material or a piece of
I
duplicate material. I f the depth i s not
suitable for the screw, continue adjusting
until the proper depth setting i s obtained.
-
NOTE :
Before starting your job, always test-drive
a
sample screw into
a
piece of the installation
workpiece so that you are sure to have the right depth and desired adjustment.
Switch action
Tool speed is increased by increasing pres-
sure on the trigger. To start the tool,
simply pull the trigger. Release the trigger
to stop. For continuous operation, pull the
trigger and then push in the lock button.
To stop the tool from the locked position,
pull the trigger fully, then release
it.
CAUTION :
Before plugging in the tool, always check to see that the trigger switch actuates properly
and returns to the "OFF" position when released.
NOTE :
Even with the switch on and motor running, the bit will not rotate until you fit the point
of the bit in the screw head and apply forward pressure to engage the clutch.
6
Advertisement
