Identification Codes - Kenwood TK-7360 Instruction Manual

n Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Selcall or Selcall + Status.
3 Press /
or <B/C> to select the ID of the station you want to call.
• You can also enter the station ID directly by using the keypad.
4 Press the PTT switch and begin your conversation.
• You can also press
n Receiving
If enabled by your dealer, an alert tone will sound and the LED will blink when
a Selcall has been received. To respond to the call, press the PTT switch and
speak into the microphone.
n Identification Codes
An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.
Each transceiver must have its own Fleet and ID number.
Note: The ID range may be limited by programming.
p c
Aging All
1 Select your desired zone and channel.
2 Press the key programmed as Paging Call to transmit your PTT List ID, to
request a call.
S m
tAtuS eSSAge
Status messages are 2-digit codes ranging from 0 to  (0 ~  are reserved
for special messages).
A maximum of 5 received messages can be stored in the stack memory of your
transceiver and can be reviewed after reception. The
message is stored in the stack memory.
n Transmitting
If programmed by your dealer, you can press the Call 1 ~ Call 3 keys to
quickly send preprogrammed status messages. You can also manually send
status messages.
1 Select your desired zone and channel.
2 Press the key programmed as Status or Selcall + Status.
• When pressing the Status key, the target Fleet/ ID is fixed and cannot be
selected. Skip to step 5 to continue.
3 In Selcall mode, press / (if the key assignment list selection is configured
as "Enabled") or <B/C> to select the ID of the station you want to call.
• You can also enter the station ID directly by using the keypad.
2
(if the key assignment list selection is configured as "Enabled")
to page the ID, rather than talking.
n
icon appears when a