Safety Label Locations; Setting-Up Your New Snowthrower - Honda HS520A Owner's Manual

SAFETY LABEL LOCATIONS

The label shown here contains important safety information. Please
read it carefully. This label is considered a permanent part of your
snowthrower. So if the label comes off or becomes hard to read,
contact your authorized Honda snowthrower dealer for a replacement.
DANGER
KEEP HANDS
FEET AWAY
AUGER WHILE
ENGINE IS RUNNING.
CAUTION
HOT MUFFLER CAN BURN YOU.
Stay away if engine has been
running.
READ
OWNER'S
MANUAL
BEFORE
OPERATING.
DANGER
AND
KEEP HANDS
FROM
OF DISCHARGE
CHUTE WHILE
ENGINE IS RUNNING
WARNING
STOP ENGINE.
WAIT FOR ALL
DO NOT DIRECT
MOVEMENT TO
DISCHARGE AT
STOP BEFORE
BYSTANDERS
SERVICING
OR WINDOWS.
MACHINE.
SETTING-UP YOUR NEW
SNOWTHROWER
TOOLS REQUIRED
12 mm wrench, 10 mm wrench, and a Phillips screwdriver
UNPACKING
1. Remove all the cardboard. Inspect the loose parts. Missing parts
can be obtained from the Honda dealer who sold you the
snowthrower.
Qty. Description
4 Curved head bolt 8 x 40 mm
OUT
4 Flange nut, 8 mm
4 Curved washer, 9 mm
3 Phillips head shoulder screw
6 x 12 mm
3 Flange nut, 6 mm, Nylock
2 Cable tie (AS model only)
2 Key (AS model only)
1 Honda Genuine oil
2. Loosen and remove the curved-head bolt, flange nut, and starter
bracket from the lower handlebar. Do not discard the hardware.
ASSEMBLY
1. Install the handlebar
with the hardware
shown. Tighten the
flange nuts securely.
2. Pull the clutch cable
enough to insert the
"Z" fitting on the cable
through the auger
clutch lever as shown
here. Check the lever
free play as shown on
page 13.
Part number
90109-VA4-000
94050-08000
90501-898-000
90112-V10-000
90303-V10-000
32901-VB5-A00
35110-766-003
08207-5W30
9 mm CURVED
8 mm FLANGE
WASHER (4)
NUT (4)
8 x 40 mm
CURVED HEAD
BOLT (4)
AUGER
CLUTCH
LEVER
"Z" FITTING
3