Hi-Fi Dsp Programs - Yamaha HTR-5540 Owner's Manual

Problem Cause Remedy Refer
to page
12 The sound suddenly
goes off.
Only the speaker on
one side can be
heard.
No sound from the
effect speakers.
No sound from the
center speaker.
No sound from the
rear speakers.
No sound from the
subwoofer.
Poor bass
reproduction.
The protection circuit has been activated Check the IMPEDANCE SELECTOR switch is set
because of a short circuit, etc. to the appropriate position and then turn this unit
back on.
Check the speaker wires are not touching each other
and then turn this unit back on.
The sleep timer has functioned. Turn on the power, and play the source again.
The sound is muted.
Press MUTE or any operation buttons of this unit to
cancel a mute and adjust the volume.
Incorrect cable connections. Connect the cables properly. If the problem persists, 10, 1l
the cables may be defective.
Adjust it to tile appropriate position. Incorrect setting of "5 L/R BALANCE"
on the SET MENU.
Press STEREO/EFFECT to turn it on. The sound effect is off.
A Dolby Surround, Dolby Digital or
DTS decoding DSP program is being
used with material not encoded with
Dolby Surround, Dolby Digital or DTS.
A 96-kHz sampling digital signal is
being input to this unit.
Select another DSP program.
Raise tile level of the center speaker. The output level of the center speaker is
set to minimum.
"1A CENTER" on the SET MENU is set Select the appropriate mode for your center speaker.
m NON.
One of the Hi-Fi DSP programs (1 to 4)
has been selected (except for 5ch Stereo).
The source encoded with a Dolby Digital
or DTS signal does not have a center
channel signal.
Select another DSP program.
Raise tile output level of tile rear speakers. The output level of the rear speakers is
set to minimum.
Select another DSP program. A monaural source is being played with
program 9.
"ID BASS" on tile SET MENU is set to Select SWFR or BOTH.
MAIN when a Dolby Digital or DTS
signal is being played.
"ID BASS" on tile SET MENU is set to
SWFR or MAIN when a 2-channel
source is being played.
The source does not contain low bass
signals (90 Hz and below).
Select BOTH.
Select MAlN. "ID BASS" on tile SET MENU is set to
SWFR or BOTH and your system does
not include a subwoofer.
The speaker lnode settings (main, center, Select the appropriate position for each speaker
or rear) on the SET MENU does not based on the size of tile speakers in your
match your speaker configuration, configuration.
43
28
26 - 33
45
41
26 - 33
45
26 - 33
42
42
42
41,42
49