First Steps; Serial Plate - Frigidaire CFU17F3AW10 Owner's Manual

FirstSteps
!,
H nstallation
DISCARD T_E (4) CRATIN(,
SCREWSAND (2) WOOD BASES
Unpacking and Leveling - Upright Freezers
Base
Figure 1
_To allow door to
chose and seamproperly, DO NOT let
food packages extend past the front
of sheBves.
SheHfFront
Before starting the freezer, follow these important first steps:
Installation
* Choose a pHacethat is neara grounded eHectricaH outHet.
* Forthe most efficient operation, the freezershouHd be Hocatedwhere surround-
ing temperatures wHH not exceed 110°F (43°C). Temperatures of 32°F (O°C) and
beHowwHH NOTaffect freezeroperation. AdditionaHcompressorheatersare not
recommended.
* A/low space around the unit for good air cimulation. Leave a 3 inch (75 mm)
space
on aHH s ides of the freezer for adequate drcuHation.
Leveling
The freezer must have aHH b ottom corners resting firmHyon a sofid floor, The floor
must be strong enough to support a fuHHy H oadedfreezer, Check the cabinet with
a HeveH from side to side. After discarding the crating screws and wood base, HeveH
the cabinet.
To Level Upright Unit:
Once HeveHed, sHightHy raise adjustment of front feet so the door cHoseseasiHywhen
opened about haHfway.
To LeveJ Chest Unit:
Hf n eeded, add metaHor wood shims between feet pads and floor.
C_eaning
* Wash any removabHe parts, the freezerinterior, and exteriorwith miHd detergent
and warm water. Wipe dr},. DO NOT USE HARSH CLEANERS ON THESE
SURFACES.
Do not use razor bHades or other sharp instruments, which can scratch the
appHiance surface when removing adhesive HabeHs, A ny gHueHeft f rom the tape
can be removed with a mixture of warm water and miHd detergent, or touch the
residue with the sticky side of tape aHready removed, DO NOT REMOVE THE
SERIAL PLATE.
Door Remova_ (upright modeJs)
If door must be removed to fit through narrow doorways:
1. GentHyHayfreezer on its back, on a throw rug or bHanket.
2. Remove base paneH(some modeHs) by unscrewing two screws from front of
base panel (Figure 1)
3. At top of cabinet, remove pHastictop hinge cover.
4. Remove screws from top hinge.
5. Remove top hinge from cabinet. Lift door off Howerhinge pin.
6. After door is removed, remove the two screws from bottom hinge.
7. To repHacedoor, reverse above order, and secureHytighten aHH s crews to prevent
hingesHippage.