Troubleshooting; On-Screen Messages; Trouble Symptoms And Remedies - Sony SDM-S51R Operating Instructions Manual

Troubleshooting
Before contacting technical support, refer to this section.
On-screen messages
if there is something wrong with the input signal, one of the
following messages appears on the screen. To solve the problem,
see "Trouble symptoms and remedies" on page 18.
If OUT OF SCAN RANGE appears on the screen
This indicates that the input signal is not supported by the
monitor's specifications. Check the following items.
If CABLE DISCONNECTED appears on the screen
This indicates that the video signal cable has been disconnected
from the currently selected connector.
GO TO POWER SAVE
The monitor will entar the power saving mode after about 5
seconds from the message is displayed.
_ ] i L,][.l_j _1,_.. Rgll
OUT OF SCAN RANGE
xx.xkHz/ xxHz
If "xx.x kHz/xx Hz" is displayed
This indicates that either the horizontal or vertical fi'equency
is not supported by the monitor's specifications.
The figures indicate the horizontal and vertical frequencies of
the current input signal.
If "RESOLUTION > XGA" is displayed (SDM_S51 R)
This indicates that the resolution is not supported by the
monitor's specifications.
If "RESOLUTION > SXGA" is displayed (SDM*S71R/
$81R)
This indicates that the resolution is not supported by the
monitor's specifications.
If NO INPUT SIGNAL appears on the screen
This indicates that no signal is input.
II ,t .......
iiii
NO INPUT SIGNAL
GO TO POWER SAVE
GO TO POWER SAVE
The monitor will enter the power saving mode after about 5
seconds from the message is displayed.
17