Grizzly H6193 Instruction Sheet

EyE/EAR INJURy HAzARD!
Wear safety glasses and
hearing protection during
use of this tool!
Always disconnect tool from
air to prevent unexpected
operation during service!
Never exceed 90 pSI! Always
use accessories with correct
speed rating.
RESpIRATORy HAzARD!
Grinding
dust. Wear the appropriate
protection during use!
Introduction
No load speed is 22,000 RPM and collet size is
Requires a maximum of 90 PSI with a minimum of
4 CFM compressor capacity. Air inlet is
exhaust is in the front. Weighs 1.2 lbs.
Inventory
A. Die Grinder ................................................. 1
B. Wrenches ................................................... 2
Operation
Insert your ⁄ " shank tool into the collet. Using the
1
4
two wrenches, secure tool by tightening the collet
against the spindle.
CoPyRIGHt © FebRUARy, 2006 by GRIzzly INDUStRIAl, INC. RevISeD SePteMbeR, 2009 (bl)
WARNING: NO pORTION OF THIS MANUAL MAy BE REpRODUCED IN ANy SHApE
OR FORM WITHOUT THE WRITTEN AppROvAL OF GRIzzLy INDUSTRIAL, INC.
INJURy HAzARD!
EXpLOSION HAzARD!
produces
⁄ " and air
1
4
#PC8031 PRINteD IN tAIWAN
INSTRUCTION SHEET
fine
Die Grinder MUSt have 3-4 drops of oil directly
dropped into the air fitting before each use as
shown in Figure 2.
⁄ ".
1
4
Figure 2. lubricating directly into air fitting.
If you need help with your new pneumatic tool, call
our Tech Support at: (570) 546-9663.
MODEL H6193
⁄ " INDUSTRIAL
1
4
DIE GRINDER
Figure 1. Model H6193.