Troubleshooting for Anynet +
Problem
Possible Solution
Anynet+ does not work.
•
Check if the device is an Anynet + device. The Anynet+ system supports Anynet + devices only.
•
Connect only one receiver (home theater).
•
Check if the Anynet + device power cord is properly connected.
•
Check the Anynet + device's Video/Audio/HDMI 1.3 cable connections.
•
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet+ setup menu.
•
Check whether the TV remote control is in TV mode.
•
Check whether it is Anynet + exclusive remote control.
•
Anynet + doesn't work in certain situations. (Searching channels, Operating Media Play, Plug &
Play, etc.)
•
When connecting or removing the HDMI 1.3 cable, please make sure to search devices again or
turn your TV off and on again.
•
Check if the Anvnet + Function ofAnynet + device is set on.
I want to start Anynet +.
•
Check if the Anynet+ device is properly connected to the TV and check if the Anynet + (HDMI-
CEC) is set to On in the Anynet + Setup menu.
•
Press the TV button on the TV remote control to switch to TV. Then press the TOOLS button to
show the Anynet + menu and select a menu you want.
I want to exit Anynet+.
•
Select View TV in the Anynet+ menu.
•
Press the SOURCE button on the TV remote control and select a device other than Anynet+
devices.
•
Press V CH A, CH LIST, PRE-CH, and FAV.CH to change the TV mode. (Note that the
channel button operates only when a tuner-embedded Anynet + device is not connected.)
•
You cannot use the remote control when you are configuring Anynet + or switching to a view
mode.
•
Use the remote control when the Anynet + setting or switching to view mode is complete.
•
You cannot use the play function when Plug & Play is in progress.
The message 'Connecting to
Anynet+ device...' appears on
the screen.
The Anynet+ device does not
play.
The connected device is not
displayed.
The TV program cannot be
•
recorded.
The TV sound is not output
•
Connect the optical cable between TV and the receiver.
through the receiver.
•
Check whether or not the device supports Anynet + functions.
•
Check whether or not the HDMI 1.3 cable is properly connected.
•
Check whether Anynet + (HDMI=CEC) is set to On in the Anynet + setup menu.
•
SearchAnynet + devices again.
•
You can connect an Anynet + device using the HDMI 1.3 cable only. Some HDMI cables may not
support Anynet + functions.
•
If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power cord
or a power failure, please repeat the device scan.
Check whether the antenna jack on the recording device is properly connected.