Digital Audio Setup; Equalizer (Sound Node); Reverb Node) - Yamaha DV-SL100 Owner's Manual

Setup Henu
DIGITAL AUDIO SETUP
In this menu, you can set up the digital audio output signal
from the digital jacks, such as coaxial etc,
EQUALIZER (Sound Mode)
The "EQUALIZER" allow you to select from various
preset modes that control the frequency bands of sound
DIGITAL OUTPUT
1 Press AT to highlight DIGITAL OUTPUT,
2 Enter its submenu by pressing I_,
3 Press AT to highlight the selected item,
to optimize certain musical styles.
It greatly enhances the excitement and enjoyment
of your favourite music.
Press AV to highlight the
"EQUALIZER".
Enter" its submenu "SOUND MODE" by pressing ,.
-_ ALL: Original digital signals output. In this mode, all
audio settings except MUTE are invalid,
-t_ PCN Only: If your receiver is PCN-compatible, or
your receiver can not decode MPEG-2, Dolby Digital, or
DTS audio, choose this option,
4 Press ENTER/OK,
5 Press _ and return to the Audio Setup Page,
Note: If DIGITAL OUTPUT is set to "'ALL" all audio settings
except MUTE are invalid.
LPCM OUTPUT
In this menu, you can select PCM digital output between
48kHz and 96kHz,
1 Press AT to highlight the "LPCH OUTPUT",
2 Enter its submenu by pressing I_,
3 Move the cursor by pressing AV to highlight the selected
item.
-_ 48K: 96kHz (if available on disc) PCN data stream will
be converted to 48kHz,
4 96K: If the 96kHz disc is copy protected, the digital
output will be muted to comply with the standards,
4 Press ENTER/OK,
5 Press _ to return to the Audio Setup Page,
3 Press I1_.
4 Move the cursor by pressing A_' to highlight the selected
item.
NONE: Playback the disc under the original sound
effect.
5 Press ENTER/OK.
6 Press _ to return to the Audio Setup Page.
Note: The sound may be distorted if the selected sound
mode is incompatible with the disc contents.
In that case, select another sound mode or "'NONE"
3D (REVERB HODE)
The "3D" can simulate the echoes and
frequency response of some particular places so as to
make you feel like personally on the place.
1 Press AV to highlight the "3D".
2 Enter its submenu "REVERB MODE" by pressing I_.
3 Press I_.
4 Move the cursor by pressing AV to highlight the selected
item.
OFF: Playback the disc under the original sound effect.
5 Press ENTER/OK,
6 Press _ to return to the Audio Setup Page,
16