Radio Operations; Tuning To Radio Stations; Changing Tuning Grid; Presetting Radio Stations - Philips HTS3000 User Manual

Radio Operations
Before you start ...
Make sure the FM and AM/MW antennas
are
connected,
Tuning to radio stations
Press SOURCE repeatedly until 'FM'
appears on the display panel (or press
RADIO on the remote control),
Press 4 / _ on the remote control to
start tuning.
.... _ The frequency indication starts to
change until a radio station with sufficient
signal strength is found,
Repeat step @ if necessary until you find
the desired radio station
Presetting radio stations
You can store up to 40 FJvl and 20
AM/MW preset radio stations in the
memory. There are three different ways
to program the radio stations:
- Using auto install (for first time setup
only)
- Using automatic preset
- Using manual preset
Helpful Hints:
- This unit exits presetting mode if no
button is pressed within 20 seconds.
- If no stereo signal is detected or less than
5 (five) stations are detected during radio
installation, "CHECK ANTENNA' appears.
@
To fine-tune the reception of a weal<
station, press • / • briefly and
repeatedly until an optimal reception is
found.
Changing tuning grid
(only applicable for certain regions)
In some countries, the frequency step
between adjacent channels in the (AM/
PlW)/FP1 band is 9 kHz/50 kHz ( I 0 kHz!
100 kHz in some areas).
Note:
Changing the tuning grid erases all
previously
stored preset radio stations.
Press SOURCE repeatedly until 'FPI' or
'API/P1W' appears
@ Press I[
Press and hold l_l! until 'GRID 9' or
'GRID 10' appears.
When you access the _RADIO' mode for
the very first time, you will be prompted
to install the radio stations. With this
feature, you can install all the available
radio station automatically with one
touch of button.
......
--i_||
Press RADIO.
.... ÷ 'AUTO iNSTALL ... PRESS PLAY'
appears.
38