Dishwasher Feedback Section; Canceling A Cycle; Changing A Cycle After Dishwasher Is Started; Adding A Dish After Dishwasher Is Started - Maytag MDB7749SAM0 User Instructions

CONTROL
PURPOSE COMMENTS
[] wash I dry I clean I sanitized
The Cycle Status Indicator Clean indicator glows when a cycle is finished.
Ligh2s areused _°o_ll°wh_e If you select the Sani Rinse option, when the Sani Rinse cycle is finished,
•,_u,_?o ,_.L,'7 "'_,' vv_o,'Z' the Sanit zed indicator glows. If your dishwasher did not properly sanitize
cyc,Je. Located, on t nejrom your dishes, the light flashes at the end of the cycle. This can happen if the
of tne alsnwasner for Tront
c;'ntr'_lu u m_dels,u and 12_ate dU,_ cycle is interrupted, or the water could not be heated to the required
on the top of the door for temperature.
hidden control models. The Clean and Sanitized lights go off when you open and close the door or
press CANCEL.
Canceling A Cycle
1. Open the door slightly to stop the cycle. Wait for the spraying
action to stop before completely opening the door.
2. Press CANCEL/DRAIN button once. The Cancel/Drain light will
light up.
3. Close the door and the dishwasher starts a drain cycle (if water
remains in bottom of dishwasher). Let the dishwasher drain
completely. The Cancel/Drain light turns off after 2 minutes.
Changing A Cycle After Dishwasher Is Started
1. You can interrupt a cycle and restart your dishwasher from the
beginning using the following procedure.
2. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
3. Check that detergent dispenser cover is still closed. If cover is
open, you will need to refill the detergent dispenser before
restarting your new cycle.
4. Press CANCEL!DRAIN twice to reset the control.
5. Select new cycles and options.
6. Press START/RESUME.
Adding A Dish After Dishwasher Is Started
1. Check if Add a Dish indicator is lit. (Available on some models.
Otherwise, proceed to Step 2.)
2. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
3. Check whether the detergent dispenser cover is still closed. If
it is open, the wash cycle has already started and adding a
dish is not recommended.
4. If detergent has not yet been used (detergent dispenser cover
is closed), you may add a dish.
5. Press START/RESUME.