Table of Contents
Advertisement
Projection
TV
+ antenna
or cable
with
a decoder
box
equipment
you_l
need
Use this hook-up if you need a decoder box to descramble
cable signals.
This hook-up
wil! allow you to use the remote
control
to change
channels.
To complete
the hook-up, you'll need:
1 two-way splitter,
and
3 lengths
of 75 ohm coaxial
cable.
procedure
(See illustration on the following page.)
O Connect
the incoming
cable to the ]:N terminal
on the two-way
splitter.
O Connect
a coaxial
cable to one of the OUT terminals
on the same
splitter;
connect the other end of this cable to the ANT-A terminal
on the back of the Projection TV.
Connect the second coaxial cable to the s_,cond OUT terminal
on the
same splitter;
connect the other end of this cable to the IN terminal
on the decoder box.
O Connect the third coaxial cable to the OUT terminal
on the back of
the decoder box, and the other end of this cable to the _'_qT-B termi-
nal on the back of the Projection TV.
Basic Connections
31
Advertisement
Table of Contents
