Advertisement
III
II
IIIIIII I
IIIIIIIIIII I
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
II
IIIIIII
IIII
IIIIIIII II IIIIIIIIIII
IIIIIIIIIIIIIIIIIII
cording to model.)
For REGULARFABRICloads, turn the control knob
to 12 minutes Fora HEAVY cycle; to 8 minutes For
a NORMAL cycle; and to 5 minutes for a LIGHT
cycle.
For PERMANENT PRESSloads, turn the control
knob to 10 minutes for a HEAVY/NORMAL
cycle, and to 5 minutes for a LIGHT cycle. Due to
the extra coot down rinse which minimizes
wrinkling, this cycle can also be used for non-
permanent press items when additional rinsing is
needed. NOTE: On some models a separate
NORMAL cycle (7 minutes) can be selected.
Presoaking:
The SOAK ONLY cycle (not on all models) is used
to soak heavily soiled or stained items. The
washer does not advance automatically into a
wash cycle.
To usethe SOAK cycleturn the control knob to
start. The washer will fill, agitate for
approximately 3 minutes and soak until the
control knob is advanced into a wash cycle or
spin and drain. Generally,
soak periods
up
to 30 minutes
are sufficient
for most
loads (overnight
soaking
is not
necessary
or recommended).
If Following
the soak with a regular wash, use up to 50%
more than the usual amount of detergent or use a
presoak product such as Biz* in addition to the
regular amount of detergent.
*Brand names are trademarks of the respective manufacturers.
Start the Washer
Pull out the cycle control knob to start the washe
It wi!l fill to the selected water level with the
selected wash water temperature. After filling, it
will agitate for the selected number of minutes.
The washer will pause briefly throughout each
cycle. These pauses are normal.
This washer is designed so that it will not agitate
or spin when the lid is open. It will, however, fill
with the lid open so water is available for
pretreating stainsor diluting fabric softener.
Should the lid be opened during a cycle, the
washer will stop; when the lid is closed and the
control knob is pulled out, the washer will resume
its cycle at the point it was interrupted.
NOTE: tf an unbalanced load occurs during the
spin, the washer will automatically stop.
if this happens, push in the control knob,
open the lid, redistribute the load, close
the lid and pull out the control knob.
Indicator
Lights
(Not on all models)
The ON light stays lit throughout the entire cycle
indicating the washer is operating. The SOAK
light is on during the soak cycle.
IIIIIIIIIIIIII!, IIIIIIIII1,1!1!!! IIIIIII1_
IIIIIIIIIIIII!1!!!! IIIIIIIIIIII!11111!
IIIIIIIIIIIIIIIII1! I
III
PAGE 5
Advertisement
