Advertisement
USING THE DRYER
Check the Lin
Clean the lint filter after each load. It's best to
check this when the dryer isempty to prevent lint
from falling onto items inside the dryer.
To clean, pull the filter out and remove any lint.
(See illustration below.) Failure to clean the filter
will cause loads to take longer to dry and make
the dryer operate less efficiently.
Replace the filter by pressing it firmly into position.
NOTE: Do not operate the dryer without the lint
filter in place.
Load
D ÷r
A proper washer load is a proper dryer load. Do
not combine loads. Avoid drying very small loads
or mixed loads of heavy, hard-to-dry items and
ligh_eight ones. Normal sized loads dry most
efficiently. (A full load is shown below.)
NOTE: If you are using a dryer-added fabric
softener,it should be added before
starting the dryer. Adding one after the
load is warm can cause greasy-looking
softenerstains. Refer to the Maytag
LaunderingGuide for removing dryer-
added fabric softenerstains.
Wha
Cannot Be D er
Dr ÷d
The following itemsshould not be dried in a dryer
untess specifically recommended by the
manufacturer on the care label.
1. Fiber glass items(curtains, draperies,
bedspreads, etc.)
2. Woolens
3. Rubber.coated items,plastics and itemswith
plastic trim (on a heat setting)
For specific drying instructions, please refer to the
Operating Instructions section on pages 4 and 5
or the MAYTAG LAUNDERING GUIDE.
PAGE 6
Advertisement
