Advertisement
The S(uper)-Video connection on
the rear of the television can give
you better picture detail and
clarity, for the playback of S-
VHS VCR tapes, or Digital Video
Discs than the normal antenna
picture connections.
Note: The VCR (or Digital Video
Disc player) must have a S-
VIDEO OUT(put)jack
in order
for you to complete the connec-
tions shown on this page.
<_
the S-VIDEO
Connect
CABLE to the S-VIDEO input
jack on the rear of the television,
then the AUDIO (red and white)
to the AUDIO IN (IN 2) jacks on
the rear of the TV.
<_
Connect the S-VIDEO
CABLE to the S-VIDEO output
jack on the accessory device.
Then connect the red and white
AUDIO CABLES to the AUDIO
(left and right) output jacks on
the rear of the accessory device.
<_
Turn the VCR (or Digital
I Video Disc Player) ON.
<_
Press the AV button on the
remote to tone to the SVID-R
channel. You are now ready to
view the tape or disc on the TV.
O
NOTE: Relatedly
pcessing the AV
button
on tbl_ remote
will toggle
the
picture source from the current chan-
nel (Tuner A o¢ B), to the SVID-R
connection, to the AV I connection,
to the AV 2 connection.
This also applies to the Multi Media
baron on the remote. Repeatedly
pressing the Multi Media button will
Ioggle the picttm: source from the
current channel (Tuner A Or B), to
the MM I (SVID-R) connection, to
the MM 2 (AV l) connection,
to the
i MM 3 (AV 2) connection.
24
A¥1
A¥ 2
• i_
II
SVID-R
S-VII_O CABLE
(NOT SUPPLIED)
@
VIDEO IN
(YELLOW)
BACK OF "IV
DS$, DVD. _rtdeo Gsane, etc,
(EQUIPPED WITH S-VIDEO AND
AUDIO O_
JACKS)
H: YOU ARE USING A
MONO DEVICE, USE
ONLY THE AUDIO
R/MONO JACK.
parallel. The S-VIDEO input is
dominate when in use. If seperate
video signals are connected to the
S-Video and the VIDEO IN-2
Inputs, the signal from the VIDEO
IN-2 input will be unuseable.
If you have added SVID-R to the
TV's channels memory, just press
the CHANNEL + or - buttons to
select the S-VIDEO mode.
U
23
Advertisement
