Installation Instructions; Tools And Parts; Custom Overlay Panel - KitchenAid KURO24RSBX00 Use & Care Manual

INSTALLATION INSTRUCTIONS
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here,
• Hand drill or electric drill • Scissors
(properly grounded) • Masking tape
• 1/2"Brad point doweling
drill bit • Tape measure
• Phillips screwdriver • Petroleum jelly
PARTS NEEDED:
Custom Overlay Door Panel--See "Overlay Panel--Rear View."
Hardware (Optional)
PARTS SUPPLIED:
• Flat-head screws (8) • Overlay plates (2)
• Round-head screws (8) • Overlay hooks (4)
If you plan to install a custom overlay panel, you will need to
create the panel yourself or consult a qualified cabinetmaker or
carpenter. See dimension drawings for panel specifications.
IMPORTANT:
• The thickness of the wood overlay must be 3/4"(1.91 cm).
• Overlay panel must not weigh more than 20 Ibs (9.07 kg).
• Overlay panel weighing more than recommended may
cause damage to your refrigerator.
Overlay Panel-- Rear View
Create the custom overlay panel using the dimensions shown.
-
413/32 ''
1%6" (11.2 cm)
(3.33 cm)
S
/
297_ ''
(76.66 cm)
A
1%e ....... [_
(3.33 cm)
(6.4 cm)
233/4''
(60,33 cm)
A. Overlay hook locations
Install Overlay Hooks
Using a Phillips screwdriver and eight flat-head screws attach the
overlay hooks to the back of the overlay panel. See "Overlay
Panel-Rear View," for overlay hook locations.
J
A
A. Overlay hooks (4)
Door Hinge Holes
• The views of the top and bottom hinge pin hole show a right-
hand hinge. Mirror the image for a left-hand hinge.
• We recommend using a C-Clamp and two pieces of scrap
wood (front and back) to help reinforce the overlay panel
when drilling the hinge pin holes.
Using a V2" Brad point doweling drill bit, drill a _/2"(1.27 cm)
deep hole into the top of the overlay panel for the top hinge
pin as shown.
Top View
Front Surface
(1.35 mm) Back Surface
A. Radius 5.0