Options; Modifiers - KitchenAid KHWS02RWH0 Use & Care Manual

Cyde Soil Level Water Tamp Spin Speed
(cycle time)
Delicate Normal Warm/Cold Medium
(0:35)
Silk Normal Cold/Cold No Spin
(0:26)
Wool Normal Cold/Cold Medium
(0:30)
Handwaah Normal Cold/Cold Extra Low
(0:30)
Soak Normal Warm/Cold No Spin
(0:30)
Rinse/Spin Normal Cold/Cold Extra High
(0:21)
DraidiSpin Normal N/A Extra High
(0:11)
To change the preset cycle settings
Press the selector of each setting until the desired setting glows.
Normal Washer Sounds
As with any new product, you will hear sounds that you are not
accustomed to. You may hear various sounds when the door is
locked and unlocked, and during the washing, rinsing, and
spinning process. Between changes in wash actions, there will
be momentary pauses. You will hear water spraying and
splashing during the wash and rinse cycles. These new sounds
and pauses are part of normal washer operation.
Op_oTIs
You can customize your wash by adding "Options" to your cycle
selections. You can add or change an option after starting a cycle
anytime before the selected option begins. Not all options are
available with all cycles.
KJ D rl []
a
O O O O
Pmwash Auto Extra Rinse
Soak Rfnse HoM
See the "Laundry Guide" for an overview of possible options
for each Wash Cycle selection.
l You can select more than one option for a cycle. Some
options cannot be added to some cycles; for example,
Prewssh cannot be added to the Rapid Wash cycle.
a
a
If an option is available with a selected cycle, the light for that
option will glow when selected.
If an option is unavailable with a selected cycle, there will be a
short tone, and the light for that option will not glow when
selected.
Prewash
Use this option for heavily soiled loads that need pretreatmant.
This option adds a 15-minute prewssh and drain to the main
wash cycle.
NOTES:
a Add detergent to the Prewssh and Main Wash
compartments of the Dispenser Drawen
a When using Prewssh, do not use liquid detergent in the Main
Wash compartment. Use powdered detergent for the main
wash cycle.
NOTE: The Prewssh and Auto Soak options cannot be selected
in the same cycle.
Auto Soak
Use the Auto Soak option for loads of heavily soiled cotton, linen,
polyester or nylon with sst-in stains. During Auto Soak, water will
be added to the drum and the laundry will be equally distributed
by a short tumbling phase. Laundry will then be soaked by
phases without drum movement. After soaking, the washer
drains without spinning.
a Add detergent to both the Prewssh and Main Wash
compartments of the Dispenser Drawer.
a Use powdered detergent for the main wash cycle because
liquid detergent will seep into the washer during Auto Soak.
a For cycles with Hot Wash Temperatures, the Soak
temperature is set to WARM. Otherwise the Soak
temperature is the same as the Wash Temperature.
a The Auto Soak and Prawssh options cannot be selected in
the same cycle.
Extra Rinse
An extra rinse can be used to ensure the removal of detergent or
bleach residue from garments. This option provides an additional
rinse with the same water temperature as the first rinse.
Rinse Hold
Use this option to avoid wrinkling of your laundry when a load
cannot be removed from the washer immediately. The wash cycle
is paused before the final drain and spin phase so that the laundry
stays in the rinse water until the cycle is continued. This provides
optimal wrinkle care of your wet laundry. The door stays locked
during the Rinse Hold cycle and the indicator light is flashing.
Press RINSE HOLD to finish the cycle and unload the washer.
Modifiers
Preset cycle settings of Soil Level (cycle time), Water
Temperature, and Spin Speed can be changed. You can change a
modifier after starting a cycle anytime before the selected
modifier begins. Not all modifiers are available with all cycles and
options.
Ii uper Hot / Cold
O Hot / Cold
O Warm / Warm
O Warm / Cold
Cold / COld
Extra High !t 1
HighO
MediumO LoudO
Extra Low 0 ._'t 0
No Sp_n Off
O O O
WATER SPIN CYCLE
"lIMp SPEED SND
SE_
He_ for3
Io_/unl_k
a To change the water temperature, select the WATER TEM P
button until the desired setting glows.
m To change the spin speed, select the SPIN SPEED button
until the desired setting glows.
m To change the loudness of the Cycle End Signal, select
CYCLE END SIGNAL.
u u u
m To change cycle time, select SOIL LEVEL button.
Wash/Rinse Temp
Select a water temperature based on the type of load you are
washing. Use the warmest wash water safe for fabrics. Follow
garment label instructions.
14