Problems And Solutions - Kenmore 3631442190 Guide Operating Instructions Manual

Common Dishwashing Problems and Solutions
(continued)
Problem Solution
Spotting and
filming
Etching--permanent
filming which
cannot be removed
'Water left in bottom
of tub
Caused by
Hard water
Water is not hot
AIR DRY drying
option selected
Not enough or poor
quality detergent
Old detergent
No rinse agent
Too much detergent
in soft water'
Improper loading
Normal amount of
water
Drain air gap
Fill detergent cups to capacity_ Use dishwasher
detergent with highest available phosphorous
content. May be necessary to install a water' softener_
Raise water heater thermostat to 140°E
Drying without heat may cause some spotting Do
not select AIR DRY option,
Use more flesh automatic dishwasher detergent..
Use detergent with highest available phosphorous
content, especially if you have hard water
Use only fresh, automatic dishwasher detergent_
Store tightly closed in a cool dry place. Discard old
lumpy or separated detergent, Do not fill detergent
cups until ready to wash
Fill rinse agent dispenser.
To remove stubborn spots and film from glassware:
1_ Remove all metal utensils from the dishwasher.
2. Do not add detergent
3. Select POTS PANS cycle..
4. Start the dishwasher and allow to run for 18 to
20 minutes_ The dishwasher will now be in the
main wash
5. Then open the door' and pour 2 cups (500m!)
white vinegai into bottom of dishwasher.
6. Close the door and allow to complete the cycle.
If vinegar rinse doesn't work: Repeat as above, except
use 1/4 cup (60ml) of citric acid crystals instead of
vinegar (Most drugstores carry citric acid crystals..)
Reduce amount of dishwasher detergent.. Use
detergent with lower phosphorous content.
Make sure dishes and glassware are loaded properly
to permit water spray to rinse all surfaces. Do not
overload_
It is normal for- a small amount of clean water to
remain in bottom of tub after each cycle.
Clean the drain air gap. See User' Maintenance
Instructions.
I4