Kenmore 272.98201.490 Owner's Manual page 7

Step 6. Attach Partition by guiding the Connecting
Bolts into holes in the Back Brace, Back,
and Front Assembly; also allow Dowels
in the Front Assembly and Back Brace
to enter holes in the Partition (as shown in
FIG. 6).
FIG. 6
Step 7.
Attach Compartment Back to Partition, aligning Cam holes with Bolts. Panel should be flush at top
and bottom, when aligned with Bolts, turn Cams to locked position. Attach Compartment Bottom
to partition, (taped edge to front) again aligning with Bolts, turn Cams to locked position. Attach
Right Side to Compartment Back and Bottom; turn Cams to locked position (see FIG. 7).
@
.....
@ @
®
Compartme
Bottom
:_ Wood / _@
Grain Compartment
end Back
Right Side
Panel
FIG. 7
Step 8. Place Clips and Inserts, in that order, (5) where indicated
on bottom of Side Panels and Partition. Tap in Casters
(as shown in FIG. 7A), "LOCKING" type in front,
"NON-LOCKING" in the rear and on Partition.
Caster
Caster Insert
_'_ _ Caster Clip
Cabinet Side _._ "'T
Panel _1
Page 6
FIG. 7A
98200-_
98201-6