Table of Contents
Advertisement
Drying Procedures
Follow fabric care label instructions.
Place small items in a mesh bag.
• Follow the guidelines below for preparing the load for drying.
• Read the Operating
Instructions
card for operating your specific model.
• Always read and follow fabric care labels and laundry product labels.
To reduce the risk of fire, electrical shock, or injury to persons, read
Important
Safety Instructions,
pages 2-3, before operating this dryer.
1.
Prepare
items
for drying.
•
Dry items of similar fabric, weight and construction in the same load.
•
Separate dark items from light-colored items. Separate items that shed lint
from those that attract lint. If an item sheds lint, turn it inside out.
Be sure buckles, buttons and trim are heatproof and won't damage the
drum finish. Close zippers, fasten hooks and Velcro®-Iike fasteners. Tie
strings and sashes to prevent snagging and tangling.
If possible, turn pockets inside out for even drying.
Check for stains which may not have been removed in washing. Dryer heat
may permanently set some stains. Repeat stain removal process before
drying.
Placesmall items in a mesh bag to prevent tangling and for easy removal.
2. Check that lint screen is clean and in place.
3.
Load the dryer.
•
Theaverageloadwillfillthedruml/3tol/2full,
ltemsneedroomtotumble
freely for even drying and lesswrinkling, Do not overload dryer.
•
When drying large items, dry only 2 or 3 at a time. Fill out the load with small
and medium sized items.
Fordelicate or very small loads, add 2 lint-free towels for better drying, less
wrinkling, and to prevent grease stains caused by fabric softener sheets.
Do not overdryitems. Overdrying can causewrinkling, shrinkage, harshness,
and a build-up of static electricity, which can produce more lint.
If desired, add a dryer fabric softener sheet.
4. Close the dryer door.
5. Set dryer controls and turn cycle selector clockwise to the
desired settings.
•
See Operating Instructions card for your specific model controls.
6. Start the dryer.
•
Turn the Start knob clockwise to ON. Hold for 1-2 seconds and release.
•
Toadd or remove itemswhen the dryer isrunning, open the door. The dryer
will always stop when the door is opened. Allow the drum to come to a
complete stop before reaching inside.
•
To restart dryer, close the door then turn Start knob to ON. Hold for 1-2
seconds and release.
7.
When
the cycle
ends,
remove
items
immediately
and hang
or fold.
If load is removed before the cycle ends, turn cycleselectorto OFF.
Filldryerdrum 1/3 to 1/2 full.
4
Advertisement
Table of Contents
