Hitachi DSS SYSTEM Owner's Manual page 59

HITACHI DIGITAL SATELLITE S YSTEM OWNER'S MANUAL
Q How can I watch one DSS program while recording another?
A With only one DSS receiver, unfortunately, you can't. Each receiver can only decode one
channel at a time. If you are lucky enough to have two DSS receivers installed, you can use the
key to choose which DSS receiver you are controlling. You must set one receiver to be
"DSS 1" and the other to "DSS 2" on the PREFERENCES screen,
Q rm getting a message to call some extension. Why?
A There are many different reasons for this. If you want to watch the channel that is
displaying the message, call the service provider for. assistance. For channds bdow 900, call
DIRECTV at 1-800-DIRECTV (347-3288). For channels in the 900s, call USSB at 1-800-204-
USSB (8772).
Q Why don't I have an on-screen offer m purchase Pay-PerAqew (PPV) programs?
A There are three possiKt!ities; your DSS receiver must be connected to a phone line and k
is not, or your service provider doesn't realize that your phone line is connected, or your service
provider has disabled your ability to make on-screen purchases. Call your service provider, at
dtlqer 1-800-DIRECTV (347-3288) or 1-800-204-USSB (8772), for assistance.
Q Can I receive my local TV programs through my DSS system?
A To receive local programming you will need either a traditional antenna (i.e. roof
mounted, attic mounted or rabbit ears) or cable TV. Codnect this signal to the IN FROM
ANTENNA on the back of your DSS receiver. Use the _ key to switch between DSS
prograrma'm_ and local programming provided on the OUT TO TV connector.
Q If I have questions about my Hitachi-brand DSS system or need to have it serviced, who
should I call?
A Always cal! your dealer first. They are most familiar with your installation and needs.
Also, they are likely to be local to you. However, if ),our dealer cannot resolve your problem,
please contact us directly at 1-800-477-1212.
Q I think I set an event to record on my VCR_ but when I played the tape back nothing
was there. What could be wrong?
A There are several possible masons for this. First, check that the VCR was left powered
on and the input matches the output from your DSS receiver. Also test if the VCR Control cable
and VCR coded is set properly by way of the Test button on the VCR SETUP screen. Also check
if you were authorized to tape the chosen program. And finally, make sure in the future that you
set programs that you want to record to be indicated with a video tape _) symbol.
Q I picked up my telephone and it was making a hissing and squealing sound. Why?
A Your DSS receiver was reporung any PPV activity that may have occurred to the service
providers. This happens very rardy and lasts for only a minute 9r so.
Q What if my question isn't listed here?
A Call your dealer or Hitachi at 1-800-477-1212. We will do our very best to answer your
questions.
Page 52