Table of Contents
Advertisement
Installation
Instructions
Refrigerator
Models 20, 22, 25
I Questions?Carl 800-GE-CARES(800-432-2737)or visit
our
Website at: www.GEAppliances.com
In Canada, call 1-800-361-3400orvisitourWet_ite at:vvvvw.gaappliances.ca
I
BEFORE YOU BEGIN
Read these instructions
completely
and carefully.
• IMPORTANT
- Save these
instructions
for local inspector's
use.
• IMPORTANT
- Ohse,ve all
governing
codes and ordinances.
• Note
to Installer
- Be sure to leave these
instructions
with the Consumer.
• Note
to Consumer
- Keep these instructions
for future
reference.
• Skilllevel-
Installation
of this appliance
requires
basic mechanical
skills.
• Completion
time - Refrigerator
Installation
15 minutes
• Proper
installation
is the responsibility
of the
installer.
• Product
failure
due to improper
installation
is not
covered
under
the Warranty.
WATER SUPPLY TO THE ICEMAKER
(on some
models)
If the refrigerator
has an icemaker,
it will have to be
connected
to a cold water line. AGE water supply kit
(containing
tubing, shutoffvalve,
fittings and
instrncdons)
is available
at extra cost from your dealer,
by visiting our Website
at www.GEAppliances.eom
(in Canada, at www.geappliances.ca)
or from Parts
and Accessories,
800-626-2002.
REFRIGERATOR LOCATION
• Do not install the refrigerator
where the temperature
will go below 60°F (16°C) because
it will not run often
enough
to maintain
proper
temperatures.
• Install it on a floor strong enough
to support it fully
loaded.
CLEARANCES
Allow the following clearances
for ease ofinstalladon,
proper
air circulation
and plumbing
and electrical
connections.
• Sides 1/8" (4 ram)
• Top 1" (25 ram)
• Back 1" (25 mm)
A door clearance of 3/4" (19 ram) is needed for a 90 g
door opening which provides better access to the food
storage area.
ROLLERS
The rolters have 3 purposes:
•
Rollers adjust so the door closes easily when opened
about halfway.
•
Roners adjust so the refiigerator
is firmly positioned
on
the floor and does not wobble.
•
Rollers allow you to move the refrigerator away from
the wall for cleaning.
To adjust the rollml,
remove the base grille by pulling it
out at the bottom.
Turn the roller adjusting screws dockwise to raise the
refiigerator,
counterclockwise
to loweT it- Use an
adjustable wrench
(3/8" hex head bolt) or pliers.
To replace base grille, line up the clips on back ofgriUe
between the bar and the bottom of the cabinet. Push
forward until grille maps into place.
14
Advertisement
Table of Contents
