Water Lmel - GE AHR30 Owner's Manual

Usingthe dehumidifier.
Always make sure the water bucket is locked into place on the dehumidifier.
Removing Collected Water
Thereare 2 ways to remove collected water."
[] Usethebucket "_& h en the bucket is
remoxed,
the unit will shut off. Erupt' and replace the
bucket.
NOTE: S upportbucket w ith
bothhandswhen empHing.
IMPORTANT" Do not use the hose if using the
bucket to collect water. Whenthe hose is
connected, water will flow throughit onto the
floor instead of into the bucket.
NOTES:
• Do not remove the bucket while the
dehumidifieris operatingor if it hasjust
stopped operating. Thismight cause some
water to drip from the drain pan.
• Thebucket mustbe in place and securely
seated for the dehumidifier to operate.
[]
Use a hose. _&'ater can be automaticall_
emptied into a floor drain by attaching
a garden water hose (not included).
1. Remove tile bucket fl'om tile fl'ont of
tile unit.
2. Open tile drain cover on tile side of
tile unit.
3. Thread a garden hose (not supplied) onto
tile nozzle, cut to length, and lead it to tile
floor drain.
Sideof unit
4. Replace tile bucket in tile unit.
NOTE:Thebucket must be in place and securely
seated for the dehumidifier to operate.
Water Level
The deh tunidifier will tui'n off a utomaticall_
when tile bucket is fldl,
or when
tile bucke{ is
remoxed or not replaced in tile proper position.
Thebucket must be replaced in the proper position for
the dehumidifierto work. Thelight will be on and the
dehumidifierwill not run ff the bucket is not in the
proper position.