Care And Cleaning; Burner Caps; Stainless Steel - GE Monogram ZGU36N4RH3SS Owner's Manual

36" and 48" professional rangetops
Table of Contents

Advertisement

Available languages

Available languages

Care and Cleaning
Professional
Rangetops
Dual-flame
stacked
burners
Stainless
steel
surfaces
The burner consists of three parts: the burner
base, burner head and burner cap. The burner
head and burner cap can be lifted off, making
them easy to clean.
CAUTION: DO NOT OPERATE
THE
BURNERWITHOUT ALL BURNERPARTS IN PLACE.
Surface burners should be cleaned routinely,
especially after bad spillovers, which could clog
the slots and holes in the burner heads.
The electrode is located at the rear of each
burner. Do not attempt to disassemble or clean
around any burner while another burner is on. An
electric shock may result.
BurnerCap
BurnerHead
BurnerBase
Electrode
Cleaning
Lift off burner parts only when cool. Wash in hot,
soapy water. You may use a plastic scouring pad
to remove burned-on food particles.
To remove burned-on food, soak the burner
heads in a solution of mild liquid detergent and
hot water for 20-30 minutes. For more stubborn
stains, use a plastic scouring pad or toothbrush.
If the spill goes inside the burner head assembly,
wash it under running water and shake to
remove excess water.
After Cleaning
Before replacing the burner parts, shake out
excess water and then drg them thoroughlg.
To replace the burner parts:
Make surethattheburner parts arereplaced in
the correct location.
1. Replace the burner head on top of the burner
base, making sure that the hole in the burner
head is properly aligned with the electrode in
the burner base. A small gap between the
base and head is normal.
2. Place the burner cap on top of the burner
head. Make sure that the burner cap is
properly seated on the burner head.
To remove the burner parts:
,
,
Turnall controls O FF before removingany
burnerparts.
When cool, you may lift off the burner grates,
burner caps and burner heads for easier
cleaning. Do not remove the burner bases.
Burner c approperly seated
i
Burner c apnotproperly seated
Do not use a steel-wool pad; it will permanently
scratch the surface.
To clean the stainless steel surface, use
warm sudsy water or a stainless steel cleaner.
Always wipe the surface in the direction of the
grain. Follow the cleaner instructions for cleaning
the stainless steel surface.
A bottle of stainless steel cleaner is provided with
the rangetop.
To inquire about purchasing stainless steel
appliance cleaner, please call our toll-free
number, 800.626.2002 or visit monogram.com.
14

Advertisement

Table of Contents
loading

Table of Contents