Related Manuals for Philips In.Sight M100
Summary of Contents for Philips In.Sight M100
-
Page 1: User Manual
Register your product and get support at www.philips.com/welcome M100 Wireless Home Monitor User manual... -
Page 2: Your Wireless Home Monitor
Your wireless home monitor Please read and understand the accompanied safety sheet before you use this monitor. To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. What’s in box Product overview Monitor lens Microphone... - Page 3 LED light Magnetic base DC power connector Reset key...
- Page 4 Placement You can place the Monitor on a flat surface with the magnetic base. Or you can attach it to the ceiling or wall, see the pictures below: Note • Before you place the monitor, make sure the monitor is close to a power outlet. •...
-
Page 6: Connect Monitor To Wi-Fi Network
Make sure that your smartphone or tablet is connected to your Wi-Fi network. Start the App. Log in with your Philips In.Sight account – or create a new account if you don’t have an account. Follow the on-screen App instructions. -
Page 7: Use The Monitor
(0.5 ft) in front of the monitor lens. Use the monitor After set-up, you are ready to use the monitor. Launch the Philips In.Sight App on your smartphone or tablet. You can use the monitor when it is connected to your own Wi-Fi network or any other Wi-Fi network. - Page 8 Application Overview : Monitor Connection status. Green light dot means the monitor is connected to Wi-Fi, and able to stream video. Red light dot means the monitor is not connected or has a problem with connection and no video streaming is possible. In this case, make sure that the monitor is connected to Wi-Fi, and repeat the ‘3 –...
- Page 9 (you can also enable this in the settings part). 2) Make sure on your friend’s smartphone or tablet, the Philips In.Sight App is installed and that an Philips In.Sight Account is created. 3) Fill in the email address of your friend you want to share the monitor with.
- Page 10 After you have registered your account and set up the monitor via your smartphone or tablet, you can also watch it via your favourite web browser (Safari, Chrome, Internet Explorer, Firefox). Enter the following address in your web browser: www.philips.com/ insightwebview Access more options...
-
Page 11: Specifications
Specifications Note • Specifications are subject to change without notice. Output resolution VGA, QVGA Lens F2.8 Frame rate 30 fps at VGA, QVGA Focus mode 0.4 m Focus range 1 m to infinity Video format h.264 Connectivity Wi-Fi Power supply DC 5V, 600mA;... -
Page 12: Troubleshooting
• Philips In.Sight supports general WEP, WPA and WPA2. Philips recommends using WPA or WPA2 as these are safest Wi-Fi security settings. The Philips In.Sight does not support WEP Sub Key 2, 3 , 4. Please change your router settings to WPA or WPA2 if you are not able to connect, refer to your router’s user manuel. - Page 13 App. The faster the connection speed, the faster you can see the video from the Monitor. • Philips recommends high-speed Internet connection of 800kbps upload speed or above for your Wi-Fi router. When on a remote network (either another Wi-Fi network or on 3G), I can only watch for 5 minutes.
- Page 14 I want to watch more than one monitor at the same time on my tablet’s full monitor view. • You can watch more than one monitor at the same time on your tablet via in-app upgrade. Go to ‘Settings ( )’...
- Page 16 Specifications are subject to change without notice © 2012 Koninklijke Philips Electronics N.V. All rights reserved. M100_05_CCR_V3.0...