Advertisement
A
WARNING:
Your sander/polisher
should
never be connected to power supply when you
are assembling parts, making adjustments,
assembling or replacing sanding discs
or bonnets, cleaning, or when not in use.
Disconnecting
sander/polisher
will prevent
accidental starting that could cause serious
personal injury.
LOCK-ON
BUTTON
See Figure 2.
Your sander/polisher
is equipped with a "lock-on" fea-
ture, which is convenient when continuous operation
for extended periods of time is required. This feature
can be used for both high and low speeds.
To lock on, depress the switch trigger, push in and
hold the "lock-on"
button located on the side of the
handle, then release the switch trigger. Release "lock-
on" button and your sander/polisher
will continue
running. To release the lock-on feature, depress switch
trigger and release it.
AUXILIARY
HANDLE
See Figure 2.
An auxiliary handle is packed with your sander/pol-
isher for ease of operation and to help prevent loss of
control. Any loss of control could result in an accident,
causing possible serious personal injury.
The motor housings are designed so that the auxiliary
handle can be installed on either side of the unit.
TO INSTALL:
[] Fit bolt through hole in motor housing and thread
into hex nut provided internally.
[] Tighten bolt and handle securely.
INSTALLING
OR REMOVING
RUBBER
DISC
See Figure 3.
[] Unplug your sander/polisher.
_1
WARNING:
Failure to unplug your sander/
polisher could result in accidental starting
causing possible serious personal injury.
AUXILIARY HANDLE
Fig. 2
SPINDLELOCK
HOLE
Fig. 3
[] Position the tool as shown in figure 3 and align the
spindle lock hole with the two half-circle notches
in motor housing. Lock spindle by inserting the pin
provided through spindle lock hole and trapping it
in half circle notches. This will prevent spindle from
rotating.
[] Thread rubber disc, flat face up, onto spindle in a
clockwise direction. Turn until rubber disc shoul-
ders on the spindle.
[] The unit is now ready for installation of the sanding
disc or polishing bonnet.
ELECTRICAL
CONNECTION
Your sander/polisher
has a precision built electric
motor. It should be connected to apower
supply that
is 120 volts, 60 Hz, AC only (normal household
cur=
rent). Do not operate this tool on direct current (DC).
A substantial voltage drop will cause a loss of power
and the motor will overheat. If your tool does not op-
erate when plugged into an outlet, double-check
the
power supply.
Advertisement
