Contents; Basic Tools And Materials Needed; Installation - Craftsman 390.291352 Owner's Manual

CONTENTS
W._NTY ........... , ................. , .... ,, .... ,, ............. ,.o,.., ..... ,.2
SAFETY ............................................................................ 2
INSTALLATION ............................................................. 3-6
OPERATION ...................... :............................................. 7
SERVICE HINTS ............................................................ 7-9
REPAIR PARTS ........................................................... 10-11
INTRODUCTION
Please read our instructions before you install and use your
tank. This will help you obtain full benefits from this tank.
It will also help you avoid needless service expense that
result from causes we cannot control and cannot cover in
our Wan-anty.
BASIC TOOLS AND HATERIALS NEEDED
PLASTIC PIPE INSTALLATIONS
TOOLS HATERIALS
Pipe Wrenches
Screwdriver
Knife or Saw to Cut Plastic Pipe
Tire Pressure Gauge
Plastic Pipe and Fittings (as required to complete job).
Teflon Tape (DO NOT use pipe joint compound on
plastic fittings) or Plasto-Joint Stik*
GALVANIZED STEEL PIPE INSTALLATIONS
TOOLS
Pipe Wrenches
Screwdrivers
Pipe Cutting and Threading Tools
Tire Pressure Gauge
HATERIALS
Galvanized Pipe and Fittings (as required to complete job).
Pipe Joint Compound or Teflon tape
INSTALLATION
,_kWARNING
ff your system can develop more than 100
Hazardous
PSI pressure, install a Sears No. 27220 re-
pressure lieve valve in system to prevent possibility
of tank blow-up.
NOTICE: DO NOT use any type of lubricant other than
water on Hose to Plastic fittings.
If rigid piping is installed to elbow on inlet flange, BE SURE
to support the piping.
For proper installation of your pump to tank, follow one
of the typical installations on Page 4 and 5. Use Teflon tape
on all threaded connections to tank.
Standard pipe fittings, such as nipples, tees and elbows
must be purchased locally. If you are using a horizontal jet
pump mounted on top of tank, Figures 3, 4 and 5, Kit No.
2788 is required. See Page 10 for contents of kit.
If your present system has an air volume control (AVC), re-
move it and plug AVC port on pump.
Complete pump, tank, and piping system MUST be pro-
tected against below freezing temperature. Failure to do
so could cause severe damage and voids the warranty.
* lake Chemical Co., Chicago, Illinois.