Battery Pack - Craftsman 315.115810 Operator's Manual

CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge- When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED.. After 30 minutes, re]nsert
the battery pack in the charger_ if the green LED continues
to remain on, return battery pack to your nearest Sears
Repair Center for checking or replacing°
NOTE."This situation only occurs when continuous use of
the tool causes the batteries to become hoL ft does not
occur under normal circumstances, Refer to "Charging
a Cool Battery Pack" for normal recharging of batterfeso
if the charger does not charge your battery pack under
normal circumstances, return both the battery pack and
charger to your nearest Sears Repair Center for electrical
check°
BATTERY PACK
SHOWN tNCHARGER
RED LED
LED
TO INSTALL BATTERY PACK
See Figure 3,
u Lock switch trigger on the ddlf by placing the direction
of rotation selector In center position.
m Place battery pack in the ddIloAlign raised rib on
battery pack with groove inside ddtl,
lit Make sure the latches on each s_de of your battery
pack snap in place and battery pack is secured in drill
before beginning operation.
CAUTION," When placing battery pack in the dril!,
be sure raised rib on battery pack aligns with groove
]nslde dMItand latches snap into pJace properly,
Improper assembly o1 battery pack can cause damage
to internal components,
TO REMOVE BATTERY PACK
See Figure 3,
Lock switch trigger on the ddl[ by placing the direction
of rotation selector in center position°
a Locate latches on side of battery pack and depress to
release battery pack from the drill.
m Remove battery pack from the ddIL
BATTERY
PACK
LATCHES
Fig° 2
DEPRESS LATCHES TO
RELEASE BATTERY PACK
Fig, 3
1I