Receiver & Remote Control Programming - Craftsman 139.53491SRT Owner's Manual

Receiver & Remote Control Programming
NOTICE: To comply with FCC rules, adjustment or modification of this
receiver and/or transmitter are prohibited, except for changing the code
setting or replacing the transmitter battery. THERE ARE NO OTHER
USER SERVICEABLE PARTS.
Your garage door opener has been factory set to operate
with the large push button on the remote control.
However, you can use either of the two small buttons, if
you prefer. And, the 3-function remote can also activate
additional garage door openers and/or light acontrols.
Your "SRT" garage door opener will operate with:
• up to four "SRT" remote control transmitters (with
green indicator lights),
• a Keyless Entry System, and
• code switch remote controls with red indicator lights.
Below are instructions for programming your opener to
match the other buttons on your remote control and any
additional remotes you may purchase. See available
accessories on page 38.
To add a remote control:
1. Press and hold the selected remote push button, see
Figure 1.
2. Then press and release the "SRT" button on the right
side panel of the opener, Figure 2. The opener lights
will flash once.
3. Release the remote push button.
Now the opener will operate when the remote control
push button is pressed.
If yon release the remote control push button before
the opener lights flash, the opener will not accept the
code.
To change the selected push button on the same
remote:
If you decide to use a different remote control button than
originally programmed into the opener, you need to erase
all the learned codes and reprogram each remote used to
operate the garage door opener.
To erase all remote control codes:
• Press and hold the "SRT" button on the opener panel
until the indicator light turns off (about 6 seconds).
All the codes the opener has learned will be erased.
• To reprogram, repeat Steps 1 - 3 for each remote
control in use.
Code programming instructions are also located on
the opener panel.
Childrenoperatingor playingwith a garagedoor opener
can injurethemselvesor others. The garagedoor could
c/ose and cause serious injury or death. Do not allow
childrento operatethe door control(s)or remotecontrol
transmitter(s).
A movinggaragedoor cou/dinjureor ki//someone under
it. Activate the opener onlywhen you can see the door
clearly, it is free of obstructions, and is properly
adjusted.
Figure 1
Select a remote control push
button to operate opener
3-Function
Remote Control
Figure 2
Garage Door Opener
(With "SRT" Button)
"SRT" Indicator
Button Light
33