Rip Fence Lock Lever Adjustment; Rip Fence Alignment Adjustment - Craftsman Contractor 113.29884 Owner's Manual

3. If fence does not spring back, the spring pressure
must be INCREASED. To do so:
A. Loosen the screws.
B. Move spring slightly toward front of fence.
4, If fence does not slide easily along the bars the
pressure of the spring can be REDUCED.
A. Loosen the screws,
B. Move spring slightlytoward rearof fe nce...tighten
screws.
WARNING: To avoid Injury from jams or kick-
backs, be sure to push properly adjusted lock
lever allthe way down until the lever rests on the
stop before using this rip fence.
SPR ING
SCREWS
SLIDE SPRING TO
ADJUST PRESSURE
RIP FENCE LOCK LEVER ADJUSTMENT
1. Check the Rip Fence Lock Lever, when locked
down, to be sure it will hold the Rip Fence securely.
It should not be difficult to push down and lock.
If lock lever does not lock fence securely:
A. Raise Lock Lever.
B, Tighten the adjusting nut using a small screw-
driver until the lever, when locked, holds the Rip
Fence securely,
If Lock Lever is difficult to push down:
A, Raise Lock Lever.
B. Loosen the adjusting nut using a small screw-
driver unti! the lever is easy to push down and
holds the Rip Fence securely.
_._%_.__ ADJUSTING NUT
RiP FENCE ALIGNMENT ADJUSTMENT
1. The RipFence must be PARALLELwith the sawblade
and Miter Gauge Grooves. Move Fence until it is
along side of groove. DO NOT LOCK IT. It should
be parallel to groove, if it is not:
A. Loosen the two Hex Head Screws.
B. Hold fence head tightly against bar in direction of
arrows on illustration, Move end of fence sothat
it is parallel with Groove.
C. Lock the fence in place by pushing down on lock
handle.
D. Altematelytighten the hex head screws.
E, Unlock and then re4ock fence. If fence is not
parallel with groove, repeat above steps until
fence is parallel with groove.
WARNING: A misaUgned fence can cause kick-"l"
backs. Followtheseinstructions untilthefence is I
properly aligned, l
HEX SCREWS
FENCE
HEAD
26