Advertisement
Available languages
Available languages
9-25333 CraftsmanProfessional R outerAdapter
Plate,for mounting
non-Craftsman
1/4" and 1/2"
shank routers to the router table. The holes for
mounting the router must be located and drilled by
the user. The fasteners for mounting the router to
the adapter plate are not included and must be
obtained separately.
9-25468 Craftsman
Guide Master Router Table
Push Shoe, aids in push shoe and hold down oper-
ations, aids in accurate measurement
and router
table setup, transforms into a miter gauge, and gives
quick setup for 1/2" sliding dovetail joints.
9-25332 Craftsman
Router Table Guide Bushing,
follows templates for repetitive routing of certain
shapes.
Refer to Parts List on Page 27.
. Ii,_WARNING
If ANY of the parts is missing,
DO NOT attempt to assemble, install, or use your
router table until the missing parts have been found
or replaced and your router table has been properly
and correctly assembled
per this manual.
• Contact your local Sears Retail Outlet for missing
or replacement
pads.
, In order to simplify handling and to minimize any
damage that may occur during shipping, your router
table comes unassembled.
° Separate all parts from the packaging materials
and check each part against the illustrations
and the
parts list at the end of this manual, to make sure that
all parts have been included. Do this before discard-
ing any of the packaging material.
Advertisement
