Safety Instructions - Craftsman 919.679470 Owner's Manual

SAFETY GUIDELINES - DEFINITIONS
This manual contains information
that is important for you to know
and understand. This information
relates to protecting YOUR
SAFETY and PREVENTmNG
EQUIPMENT PROBLEMS= To help
you recognize this information, we
use the symbols to the right,
Please read the manual and pay
attention to these sections.
I A DANGER ]
URGENT SAFETY INFORMATmON = A HAZ-
ARD THAT WiLL CAUSE SERIOUS mNJURY
OR LOSS OF LIFE.
AWARNtNG ]
iMPORTANT SAFETY iNFORMATION - A
HAZARD THAT MIGHT CAUSE SERIOUS
mNJURY OR LOSS OF UFE,
I _.CAUTJON ]
information for preventing damage to
equipment.
I NOTE J
information that you shouM pay special
attention to.
iMPORTANT SAFETY iNSTRUCTiONS
,, SAV |= TH|=S |= INSTRUCTIONS ,,
When using this product basic precautions should aJways be foltowed
including the following:
F_RSKOF ELECTF_OCUTRON AND FRF_E
HAZARD
Attempting to connect generator directly
to the electrical system of any building
structure,
inadequate electrical grounding of gen=
erator,
WHAT COULD HAPPEN
Back feeding electricity through a
building's electrical system to the
outside utility feed lines could en-
danger repair persons attempting to
restore service,
Attempting to connect to the incoming
utility service could result in electrocu=
tion,
Restoration of electrical service while
the generator is connected to the in=
coming utility could result in a fire or
serious damage if an isolator switch is
not installed,
The failure of one of the generator's
electrical devices, a broken wire, wet
surfaces, etc, could result in the entire
unit becoming electrically charged,
Contact with electrically charged
surfaces could result in electrocution,
HOW TO PREVENTIT
Never back feed electricity through a
structure's electrical system,
To connect to a structure's electrical
system in a safe manner and always
have a Double=Throw Transfer Switch
installed by a qualified electrician, in
compliance with local ordinances,
(When installing a Double-Throw
Transfer Switch, a minimum of 10
gauge wiring must be used.)
Make sure that the unit is connected
to an appropriate electrical ground, in
accordance with the requirement of
the National Electric Code, See page
8 for grounding instructions,
3 -- ENG