Wheel Kit Installation - Craftsman 580.328300 Owner's Manual

WHEEL KIT INSTALLATION
To install your wheel kit, you will need the following
tools:
• 13mm metric box, open end or socket wrench
Install Wheel Kit as follows:
1. Place the bottom of the generator cradle on a flat,
even surface. Place temporary blocks under the
cradle to ease assembly.
2. Slide axle through both axle mounting brackets on
cradle frame.
3. Slide spacer over each end of axle.
4. Install the wheel. Secure wheel on axle with
retaining pin and washer.
NOTE: Be sure to install the wheel with the air
pressure valve outboard.
5. Install other wheel in the same manner.
6. Secure the vibration mount on the support leg with
lock nut, washer, and 30mm long capscrew.
7. Fasten the support leg to the bottom of the
generator cradle using two 20 mm capscrews, two
lock washers and two flat washers. Remove
temporary blocks.
8. Position the handle below the muffler bracket on
the frame, as shown. Attach the handle with four
45mm long capscrews and four lock nuts.
9. Recheck all nuts to make sure they are tight and
secure.
Handle
/
Axle Spacer
45mm
Capscrew
/
/
Locking /
Nut //
/
%
_ Locking
_ Nut
\.
Vibration ?_
Mount _
,/ /
Washer
Support
Leg
J
J
.J
__ Flat Washer
/
M8 Flat _ Lock Washer
Washer
g_ 20mm
30mm Capscrew
Capscrew
Retaining
Pin