Craftsman 113.213780 Owner's Manual page 11

5. Remove the belt guard by "pushing in" on the two
"links".
6,
Place motor on drill press .., screw the pivot screws
into the holes.
NOTE: DO NOT SCREW THEM IN TOO TIGHT ...
EXCESSIVE TIGHTNESS COULD BEND THE
MOTOR MOUNT.
7,
Find two 5/16 in-18 hex. nuts among the loose parts
... screw them on to the pivot screws .., tighten
them with a '/2 in. wrench while preventing the pivot
screws from turning,
8. Plug motor cord into outlet inside of drill press,
9. Find the plastic CORD TIE among the loose parts ...
insert the pointed end into the hole in the motor
mount.
10. Gather up the slack in the motor cord.., wrap the
CORD TIE around it... insert one end of the TIE into
the hole in the other end. Pull it tightly to secure the
cord to the motor mount.
CAUTION: If you are using a DOUBLE SHAFT motor.
Make sure the SHAFT PROTECTOR is installed. NEVER
USE THE DRILL PRESS WiTH THE UNUSED SHAFT
EXPOSED.