Connecting The Scanner - Epson GT-5500 User Manual

Connecting the scanner

Connect the scanner to your computer or to another SCSI
device as follows:
Note:
The combination of 50-pin and 25-pin connectors you need varies
depending on the maker of your SCSI device and SCSI interface board.
1. Make sure the scanner, computer, and all other SCSI devices
are turned off and unplugged from the power source.
c
Caution:
Do not connect the scanner to the computer or other devices
while they are turned on; otherwise damage may occur.
2. Connect one end of the cable to the scanner SCSI connector;
then squeeze the wire clips together until they lock in place
on both sides.
Note:
To connect the scanner to a SCSI device other than the computer,
the length of cable in the daisy chain must be 6 meters or less;
otherwise the system may not work properly.
To connect the scanner to a PC using SCSI-2, the length of the
cable must be 3 meters or less.
1-10
Setting Up the Scanner
This is an example using the
scanner's 50-pin interface.