Specific Safety Rules For Screwdriver; Safety Rules For Power Unit - Craftsman evolv 320.17088 Operator's Manual

SPECiFiC SAFETY RULES FOR SCREWDRIVER
WARNING: To avoid injury, hold the tool by the insulated gripping surfaces
only. if the tool contacts hidden wiring or its own cord, exposed metal parts
of the tool could shock the operator and cause serious injury. Make sure that
hidden electrical wiring, water pipes, or other hazards are not in the cutting path.
WARNING: To reduce the risk of injury, user must read instruction manual.
,, Do not use dull or damaged bits and accessories.
* Only connect the power unit to a 120V AC supply.
* Before screwing into a wall, check with a metal/voltage detector to be sure
you are not driving into an electricity, gas, or water supply line.
* Avoid frequent stalling when operating, as this could damage the tool.
* if the tool stalls, release the trigger immediately, reverse the direction of
rotation and slowly squeeze trigger to back out the bit.
* Do not expose the tool and power unit to rain; also protect them from
moisture.
To protect the batteries from damage, you should never expose them to
temperature above 50 degrees centigrade. (122 ° F)
Do not charge the tool in a damp or wet location. Following this rule will
reduce the risk of electric shock.
,, Do not operate power unit with a damaged cord or plug. if damaged, it
should be replaced immediately. Contact or visit the nearest Sears service
center for more information.
,, Do not operate power unit if it has received a sharp blow, been dropped,
or otherwise damaged in any way; take it to a qualified serviceman or
contact or visit the nearest Sears service center for more information.
,, Disconnect power unit from power supply when not in use. Following this
rule will reduce the risk of electric shock, fire, or serious personal injury.
,* This power unit is intended to be correctly orientated in a vertical or
floor mount position.
SAFETY RULES FOR POWER UNIT
,_ WARNING: Read and understand all instructions. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious personal
injury.
Before using Power Unit, read all instructions and cautionary markings in this
manual, on the power unit,, and the product using battery to prevent misuse of
the products and possible injury or damage.
CAUTION: To reduce the risk of electric shock or damage to the power unit
and rool, charge only this Ni-cad rechargeable tool .Other types of batteries may
17088 Manual Revised 09-0728 Page 7