Craftsman 315.10411 Owner's Manual page 3

RULES FOR SAFE OPERATION (Continued)
12 DON'T ABUSE CORD, Never carry tool by cord or yank it to disconnect from
receptacle. Keep cord from heat, oi!, and sharp edges.
13. SECURE WORK+ Use clamps or a vise to hold work, Both hands are needed to
operate the tool
!4, DON'T OVERREACH. Keep proper footing and balance at all times+ Do not use
on a ladder or unstable support, •
t5, MAINTAIN TOOLS WITH CARE,, Keep tools sharp at all ttmes, and clean for best
and safest performance Fotlow instructions for lubricating and chang+rig ac-
cessories,
16 DISCONNECT TOOLS. When not in use, before servicing, or when changing at-
tachments, blades, bits, cutters, etc, all tools should be disconnected from
ower supply.
17 REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see
that keys and adjusting wrenches are removed from toot before turning it on
18, AVOID ACCIDENTAL STARTING,, Don't carry plugged+in toots with f_nger on
switch. Be sure switch is off when plugging in+
19, OUTDOOR USE EXTENSION CORDS, When tool is used outdoors, use only
extension cords suitable for use outdoors Outdoor approved cords are marked
wtth the suffix W.A for example -- SJTW-A or SJOW+A+
20_ KEEP BITS CLEAN AND SHARP+ Sharp bits minimize stalling and klckbac_
21+ KEEP HANDS AWAY FROM DRILLING AREA,, Keep hands away from bits Do
not reach underneath work white b_t is rotating- Do not attempt to remove
material while bit is rotating,
22_ NEVER USE IN AN EXPLOSIVE ATMOSPHERE. Normal sparking of the motor
could tgnlte fumes.
23+ INSPECT TOOL CORDS PERIODICALLY and if damaged, have repaired at your
nearest Sears Repair Center.
24 INSPECT EXTENSION CORDS PERIODICALLY and replace tf damaged,
25+ KEEP HANDLES DRY, CLEAN, AND FREE FROM OIL AND GREASE. Always
use a clean cloth when cleaning. Never use brake fluids, gasoline, petroleum-
based products or any strong solvents to clean your toot,
26 STAY ALERT. Watch what you are doing and use common sense Do not op,
erate tool when you are tired,, Do not rush
27, CHECK DAMAGED PARTS,, Before further use of the toot, a guard or other part
that ts damaged should be carefully checked to determine that It witl operate
properly and perform its intended function, Check for alignment of moving
parts, binding of moving parts, breakage of parts, mounting, and any other
conditions that may affect its operation A guard or other part that is damaged
should beproperly repaired or replaced by an authorized service center,
28+ DO NOT USE TOOL IF SWITCH DOES NOTTURN IT ON AND OFF,, Have defect,
ire switches replaced by an authorized service center.
29 DRILLING INTO ELECTRICAL WIRING IN WALLS CAN CAUSE DRILL BIT AND
CHUCK TO BECOME ELECTRICALLY LIVE. Do not touch the chuck or metal
houslng when drilling into a wail; grasp only the Insulated handle(s) provided on
the tool.,
30. Inspect for and remove al! naits from lumber before drilling.
3t DRUGS, ALCOHOL, MEDICATION, Do not operate tool while under the influ-
ence of drugs atcohol, or any medication
32 WEAR HEARING PROTECT ON DUR NG EXTENDED PERIODS OF OPERA.
TION.
33 SAVE THESE INSTRUCTIONS, Refer to them frequently and use them to
instruct third party users ff you loan someone this toot, loan them these
Instructions also,
PagB 3