Step5: Connecting The Powercord; Step 6: Preparing The Remote - Sony RDR-GX355 Operating Instructions Manual

Step5: Connecting the
PowerCord
Step 6: Preparing the
Remote
Plug the recorder and TV power cords imo all AC
outlet. Alter you connect tile power cord, you
must wait for a short while before
operating the recorder. You can operate the
recorder only afler the front panel display lights up
and tile recorder enters standby mode.
If you connect additional equipment to this
recorder (page 27), be sure to connect the power
cord only after all connections are complete.
You can control the recorder using the supplied
renlote.
lnsert two size AA (R6) batteries by matching the
(_ and O ends on the batteries to tile markings
inside the battery compartment. Be sure to close
the battery cover properly. When using the
remote, point it at the remote sensor [] on the
recorder.
to AC outlet 41,
• If the supplied remote interferes your other Seny DVD
recorder or player, change the command mode number
for this recerder (page 22).
• Use the batteries correctly to avoid possible leakage
and corrosion. Do net touch the liquid with bare hands
should leakage occur. Observe the following:
Do net use a new battery with an old battery, or
batteries of different manufacturers.
Do net attempt to recharge the batteries.
lfyeu do net intend to use the remote for an extended
period of time, remove the b itteries.
If battery leakage occurs, wipe out any liquid inside
the b ittery compartment, and insert new batteries.
• Do net expose the remote sensor (marked [] on the
front panel) to streng light, such as direct sunlight or
lighting apparatus. The recorder may net respond to the
remete.
• With nemml use, the batteries should last about three to
six months.
• Do not leave the remote in an extremely hot er humid
place.
• De net drop any lbrcign object into the rcmete casing,
particularly when replacing the batteries.
2O