Fujitsu ETERNUS User Manual page 57

Chapter 6 Messages
> 6.4 Log Messages
Send Mail "name@server" (CODE 005)
Initialize "parameter" (CODE 006)
Create File "file name" (CODE 007)
Erase File "file name" (CODE 008)
Server Status Change (CODE 012)
Work files create to "temp directory" (CODE 014)
Warning Messages for Parameter Settings (CODE 1XX)
Bad Parameter "parameter" (CODE 102)
Undefined Parameter "parameter" (CODE 103)
Parameter too long "parameter" (CODE 104)
Not NULL Parameter "parameter" (CODE 105)
P2X0-0202-04ENZ0 ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
[Explanation]An E-mail was sent.
[Response] None
[Explanation]The values set at start-up are displayed.
[Response] None
[Explanation]A file was created.
[Response] None
[Explanation]A file was deleted.
[Response] None
[Explanation]There has been a change in the target device's status.
[Response] If the component that caused the problem is included in the message, login to
the target device and check the status of that component.
When "No hardware error detected." is displayed, there is no need to do
anything. Detection of the offline status is indicated when "No hardware
report detected. (Offline)" is displayed. In this case, check for problems with
the target device, failures in the communications route, and errors in the
setup file.
[Explanation]ETERNUSmgr has created a work file in the directory indicated in this
message.
[Response] None
[Explanation]This parameter setting is invalid.
[Response] Correct the parameter setting.
[Explanation]This parameter setting is not recognized.
[Response] Correct the parameter setting.
[Explanation]Too many characters are used in this parameter setting.
[Response] Correct the parameter setting.
[Explanation]NULL is not allowed for this parameter setting.
[Response] Set the parameter.
57
Copyright 2009 FUJITSU LIMITED