Fujitsu ETERNUS VSS Hardware Provider 2.1 User Manual page 104

Chapter 9 Messages
9.2 Command Messages
■
STXV0239 ERROR Line["line number"] Foreign information found in the SnapOPC+
copy set information for a given source disk in the copy set file.
[Meaning]
The SnapOPC+ copy set information for a given source disk is interrupted by information for a different
copy source or copy type. The copy set file cannot be registered.
[Action]
Correct the copy set file so that all SnapOPC+ copy set information for each source disk is in a clean
run, and try again.
■
STXV0240 ERROR Failed to obtain device information.
[Meaning]
Device information could not be obtained. The copy set file cannot be registered.
[Action]
Check the device status, and try again.
■ STXV0241 ERROR The VSSHP Management file version is invalid.
[Meaning]
The copy set management file version is invalid. The copy set file cannot be registered.
[Action]
Use the "Backup Status Query Command" to check that no copy session exists.
For details, refer to
Then, delete the copy set management file ("installation folder"\etc\vss\copyset.cnv), and try again.
■
STXV0242 ERROR Insufficient memory.
[Meaning]
Insufficient memory. The process is canceled.
[Action]
Exit all unused programs, and try again.
If the problem still persists, refer to
required information before contacting a Fujitsu field engineer (FE).
■
STXV0243 ERROR Line["line number"] The number of characters per line exceeds
the maximum number of characters allowed.
[Meaning]
The number of characters per line of the copy set file exceeds the maximum number of characters
allowed (200 bytes). The copy set file cannot be registered.
[Action]
Correct the copy set file, and try again.
"8.5 Backup Status Query Command (stxvquery)" (page
"10.2 How to Obtain Error Information" (page
104
ETERNUS VSS Hardware Provider 2.1 User's Guide
Copyright 2012 FUJITSU LIMITED
59).
131), and prepare the
P3AM-4582-03ENZ0