Installation Instructions - Horstmann HRT4-ZW User And Installation Instructions Manual

Wireless z–wave battery operated electronic room thermostat with tpi temperature control software and asr-zw receiver unit

Hide thumbs Also See for HRT4-ZW:

Installation Instructions

Installing the ASR-ZW Receiver

The ASR-ZW receiver should be located as near as is practical to

the boiler or zone valve to be controlled, as well as a convenient

mains electricity supply. To remove the wall plate from the ASR-ZW,

undo the two retaining screws located on the underside, the wall

plate should now be easily removed. Once the wall plate has been

removed from the packaging please ensure the ASR-ZW is re-sealed

to prevent damage from dust, debris etc.

The wall plate should be fitted with the retaining screws located at

the bottom and in a position which allows a total clearance of at

least 50mm around the ASR-ZW receiver.

Direct Wall Mounting

Offer the plate to the wall in the position where the ASR-ZW is to be mounted and mark the fixing

positions through the slots in the wall plate. Drill and plug the wall, then secure the plate into

position. The slots in the wall plate will compensate for any misalignment of the fixings.

Wall Box Mounting

The wall plate may be fitted directly on to a single gang flush wiring box complying with BS4662,

using two M3.5 screws. The receiver is suitable for mounting on a flat surface only; it is not suitable

for mounting on an unearthed metal surface.

Asr-zw