Table of Contents
Advertisement
POWER SWITCH
To turn the power on and off, push the "l" and "O" sides respectively. The "POWER'
LED lights to indicate the power is on. (It takes 20 to 30 seconds for the display to be
stable. The back lights may flicker during this time.)
The monitor screen is designed to tilt up to 30 degrees upward and 5 degrees downward.
Choose the angle that suits you best.
LAMPS
POWER hlp
Indicates that power is ON.
SAVE hmlp
Glows steadily when the display is in power-save mode (power is ON, but system has
invoked power-save mode or display cable is disconnected). The SAVE lamp blinks
if the display is receiving an inappropriate (unsupported) video signal.
OSD
BUTTONS
You use these buttons to adjust the display characteristics as described in the next section.
ON-SCREEN
DISPLAY (OSD) OVERVIEW
To optimise the display use the on-screen display (OSD) as described below
The display size, image position and brightness depend on the system hardware. Make
screen adjustments after carefully reading this manual. If the screen cannot be adjusted as
desired, refer to your computer system manual to check if the display timing is consistent
with that shown on page 33.
The OSD feature supports the following adjustments:
AUTO-ADJUST:
Automatically
adjusts H-position, V-position, phase, clock, contrast
and colour balance.
MANUAL ADJUST
H-POSITION:
Adjusts the image position horizontally
V-POSITION:
Adjusts the image position vertically
PHASE: Fine tunes the display data sample rate
CLOCK: Adjusts the sampling clock to the dot timing of the computer video signal
16
CONTRAST: Adjusts the contrast
COLOR BALANCE: Adjusts the colour balance
OSD CONTROL:
Sets the time that the OSD feature waits before automatically
terminating
OSD COLOR: Selects the OSD window colour from any one of 12 colours
.
Advertisement
Table of Contents
